Gianni Industries GK770 Installation guide

Category
Security device components
Type
Installation guide

This manual is also suitable for

Copyright © All Rights Reserved. P-MU-GK760 Published: 2015.11.19
GK760 Series
The GK760 series electric strike is designed for use with cylindrical locksets
with a 18mm throw latchbolt. It can be both electrically and manually
operated if used with mechanical locksets.
Electric Strike Installation Instructions
Wiring Diagram
Operating Voltage 12~28VDC/AC
Voltage Tolerance
15%
Current Draw
230mA/12VDC, 140mA/28VDC
440mA/12VAC, 230mA/28VAC
Operating Temperature -10°C~+45°C
Humidity
0~95%
Fail-safe/ Fail-secure Conversion
Mortise Mount in Wooden Frame Optional Brackets
Butt Splice (IDC) Connector
Polarity Free Connection
Lip extension brackets are available for wider jambs.
LP-GK750-050 LP-GK750-025
50
25
50mm 25mm
Unit:mm
(unmonitored)
GK770
121.5
132.5
30.8
32
28
3
14
38.5
39.50
160
180
201
GK760
Door Status Output
Latch Recess
Keeper
Lip
Faceplate
N.C. contact or access relay for
fail-safe setting
N.O. contact or access relay for
fail-secure setting
Door Status
Switch
Wooden Frame
Copyright © All Rights Reserved. P-MU-GK760 Published: 2015.11.19
Mount the supplied template and align
to the marked line.
Connect the wires using the butt splice
connectors, then test the strike, ensure
to give it correct voltage.
Measure the vertical and horizontal
position of the latch bolt on the door
leaf.
Mark the latch bolt position on the
door frame as shown in the figure.
Drill and cut the frame according to
the template.
when opening the door..
Installation Steps
28mm
4
Electric Drill
Chisel
  • Page 1 1
  • Page 2 2

Gianni Industries GK770 Installation guide

Category
Security device components
Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI