Express Water GTS11 User manual

11 Gallon Tank Installation

1. Open the Water Storage Tank box and unscrew the Tank Stand from the threaded stem at

the top of the Tank.

2. Wrap the threaded stem 8-10 times with Teflon Tape.

3. Screw Elbow onto the Water Stem, then screw the Adapter into the Elbow. Finally screw the

Tank Valve into the Adapter. Make sure the connections are tight, but do not over tighten.

4. Connect your water supply to the inlet of the tank valve. Allow tank to fill for one minute.

5. Completely drain the tank then connect your filtration system to the tank.

6. Open your water supply and allow the tank to fill (2-4 hours) then drain tank completely.

Your tank is now flushed and ready for normal use.

NOTE! If after 3-5 hours your tank does not fill: Connect the tank directly to the cold

water supply (bypassing the RO System) and allow the tank to fill for about 1 minute. Then

reconnect to your system as normal and empty the tank through faucet. This will help

activate the tank bladder.

NOTE! Do not tamper with the air valve on the lower side of the Water Storage

Tank. It has been preset at 7-10 PSI

A. Water Valve B. Air Valve

Threaded Connections

Elbow Adapter Tank Valve

Download PDF