2. Mountain Buggy
  3. Terrain
Terrain

Mountain Buggy Terrain, Urban Jungle Designer, urban jungle/terrain travel system Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Mountain Buggy Terrain Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
mountain
buggy
®
life without limit
WARNINGS
Check you have the correct travel system for your carseat.
WARNINGS
Do not use this travel system until you have read and understood the
instructions!
WARNINGS
Never leave your child unattended.
WARNINGS
Do not use accessories not designed for your buggy as they may be unsafe.
WARNINGS
Do not leave your baby in carseat (on or off buggy) for long periods of time.
installation instructions
urban jungle
™
/ terrain
™
Peg Perego
Primo Viaggio
™
travel system
Installation instructions for the travel system that fits
the Primo Viaggio
™
infant carseat made by Peg Perego
™
.
peg perego_bi_28-07-10.indd 1 29/07/2010 12:52:21 p.m.
IMPORTANT CHECKS
• Makesurebabyisharnessedintocarseatusingthemanufacturer’s
instructions.
• Whenttingcarseatontotravelsystem,ALWAYSkeepasteady
handoncarseatandbaby,untiltravelsystemstrapissecurelyfastened.
• Checktravelsystemisengagedcorrectlyontobuggyframeand
cannot move in any direction. (Refer back to installation instructions
to ensure positioning of snap locks are correct).
• Donotusetravelsystemifyouareunabletosecurecarseatortravel
system.Inthiscase,contactyourstore/distributorwherethebuggy
waspurchasedfrom,formorehelp.
• Itisrecommendedthatyoupractisethefollowinginstructionswithout
baby in carseat.
1. Remove sunhood.
2. Unfasten domes on both sides of buggy and
peel fabric back exposing frame. Recline seat
and loosen strap beneath seat at point . (3.)
WARNING!:ALWAYSputthebuggybrakeon.
To attach travel system
Note:Thebuggyseatdoesnotneedtoberemovedtottravelsystem.
3.
1.
2.
peg perego_bi_28-07-10.indd 2 29/07/2010 12:52:21 p.m.
Remove travel system from buggy
Open all four snap locks by lifting up levers and lift travel system off buggy.
3. Open up all snap locks and press travel
system onto frame so that top snap locks
are directly above sunhood lugs (on both
sides).
5. Place carseat in travel system so that infant
is facing buggy handle bar. Ensure carseat
latches have clicked onto the travel system
bars.
6. Remove carseat from travel sys-
tem.
Pull up carseat latch handle and lift
carseat upwards.
4. Closesnaplocksdownat,makingsure
youhearthelock‘click’indicatingthey
are fully locked.
ENGLISH
peg perego_bi_28-07-10.indd 3 29/07/2010 12:52:21 p.m.
mountain
buggy
®
life without limit
Foranyassistance,pleasecontactyournearestretailerlistedat
www.mountainbuggy.com
ModelMB1-CLIP3
Issue June 2010
Safetycertied:ASTMF833-08
send 102-112DaniellSt,Newtown6021,Wellington,NewZealand
ph +6443800833
fax +6443800137
DesignedinNewZealand.MadeinChina.
peg perego_bi_28-07-10.indd 4 29/07/2010 12:52:21 p.m.
/