2. Raychem
  3. TT-FFS Extreme Cover

Raychem TT-FFS Extreme Cover, Protection extrême TT-FFS Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Raychem TT-FFS Extreme Cover Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
TraceTek TT-FFS Extreme
Environment Cover
Installation Instructions
The Extreme Environment Cover is suitable for use in outdoor
locations where the FFS is exposed to water, or where insects
and other contaminants are problematic.
Both TT-FFS-EEC-250 and TT-FFS-EEC-100 are shown here.
A
TT-FFS-EEC-250 TT-FFS-EEC-100
• Place o-ring onto FFS, approximately ¼ inch from the end.
B
• Insert FFS into clear mesh tube. When fully inserted, o-ring will be centered in tube.
C
DESCRIPTION
nVent RAYCHEM TraceTek-FFS-EEC (Extreme Environment Cover) is a kit of parts designed to provide additional protection for nVent RAYCHEM
TraceTek TT-FFS Fast Fuel Sensors (FFS) when harsh conditions warrant extra protection. The outer tube is porous but rigid. Lightweight fuels
such as gasoline and diesel fuel flow through the protective mesh tube with little or no impact on FFS response time. The flow of heavy crude oil
or other heavy fuel oils may be restricted by the outer tube in which case TT-FFS-EEC may not be appropriate for these liquids.
©2019 nVent. All nVent marks and logos are owned or licensed by nVent Services GmbH or its aliates. All other trademarks are the property of their respective owners.
nVent reserves the right to change specications without notice.
RAYCHEMTraceTek-IM-H58519-TTFFSextremecover-EN-1910
nVent.com
• Push FFS connector or lead wire end through hole in black plastic cap.
• Slide cap down cable and press onto the clear mesh tube end.
• Press the cap onto the clear mesh tube as far as possible. It will be a snug fit.
Note: The EEC should be inspected monthly for blockage.
If the mesh tube becomes contaminated with dirt or debris,
it could prevent a leak from being detected rapidly. To clean
the EEC, remove the cap, carefully remove the FFS, and wash the
EEC in water or IPA (do not remove screen!). FFS cleaning
(if necessary) is a separate operation, please refer to TT-FFS
Fast Fuel Detection Probe Care and Cleaning Instructions
(H58307).
D
North America
Tel +1.800.545.6258
Fax +1.800.527.5703
[email protected]
Europe, Middle East, Africa
Tel +32.16.213.511
Fax +32.16.213.604
[email protected]
Asia Pacific
Tel +86.21.2412.1688
Fax +86.21.5426.3167
[email protected]
Latin America
Tel +1.713.868.4800
Fax +1.713.868.2333
[email protected]
/