Öhlins Front Fork Kit for KTM Six Days / Husaberg FE/TE models
FGKT 1385
Application Specific Mounting Instructions
Issued 2012-12-19
Kit Contents (application specific)
Recommended Tools (application specific)
Hydraulic Stop Cup
Set-Up Data
Spring Recommendation
Part No. Pcs.
Front Fork kit FGKT 1385 1
Base plug (with o-rings) 15430-08 2
Spacer 2 mm 15443-02 10
Hydraulic Stop Cup 15456-06 2
Spring Support washer N/A N/A
OEM Fork Cap sleeve pin tool
Socket for OEM Base Plug 17 mm
Öhlins Fork Cap tool octagon 50 mm
Socket for Öhlins Base Plug 22 mm
FGKT 1385 Cartridge kit comes with a Öhlins Hydraulic stop
cup, that shall be installed according to step 10 in the “Owners
manual and general mounting instructions”.
Rebound Damping 15 clicks
Compression Damping 15 clicks
Spring Preload 1 mm
(with spring length 467mm, 3pcs of plastic washers in each leg
will equal 1mm preload)
Fluid Volume (each leg) 0,380 litre
Cartridge Kit FGKT 1385 shall be used together with
Öhlins Front Fork Springs part no. 08765-xx. For rate
recommendations, see Owner’s Manual/ General Mounting
Instructions.
Note!
The fork springs need to be ordered separately depending on the
rider’s choice of spring rate.
Part No. Pcs.
Circlip 15440-01 2
Öhlins Sticker 00192-01 2
TTX Cartridge Sticker 00191-40 2
Owners Manual 07296-90 1
Spring preload range -2 to 8 mm
(can be adjusted by adding/removing washers 15443-02)
Fluid volume range (each leg) 0,300 - 0,400 litre
Öhlins Front Fork uid 01309-01
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Ohlins FGKT1194 Mounting Instruction
-
-
-
-
-
-
-
-
-