LocknCharge 10024 Owner's manual

20 mm or

0.78 inches

202 mm or 7.95 inches

256 mm or 10.07 inches

DOES YOUR DEVICE FIT IN OUR 10 SLOT BASKETS? CHECK IT HERE.

TEMPLATE A - WITH FOAM.

To ensure accurate measurements, please print to scale and on a Ledger size page (portrait).

STEP 1 - Check the device thickness

Check the thickness of your device here. If the device thickness ts within the boundaries of this shape, then you

are almost there. Move on to STEP 2. If it doesn’t t, remove the foam insert and measure using TEMPLATE B.

STEP 2 - Check the device dimensions

Place your device here. If the device ts within the black boundaries of this

shape, proceed to Step 3.

If it doesn’t t, remove the foam insert and measure using TEMPLATE B.

STEP 3 - Check device charging point

Ensure that the charging point is above the dashed line. If it does, then you

are good to go.

www.lockncharge.com

PLEASE NOTE:

It is your responsibility to ensure you measure your device correctly.

If you are planning to use a case with your device, ensure you have it on whilst

checking the compatibility.

If the device is too thick with the case installed, but ts with the STEP 2 and 3,

there is one more option and that is to remove the foam insert from the basket

and measure using TEMPLATE B.

If you are still unsure, contact LocknCharge.

DOES YOUR DEVICE FIT IN OUR 10 SLOT BASKETS? CHECK IT HERE.

TEMPLATE B - REMOVE FOAM. THIS OPTION IS RECOMMENDED IF

YOU ARE STORING DEVICES WITH LARGER CASES.

To ensure accurate measurements, please print to scale and on a Ledger size page (portrait).

28 mm or

1.1 inches

268 mm or 10.55 inches

217 mm or 8.54 inches

STEP 1 - Check the device thickness

Remove the two foam blocks from the aluminum baskets. In order to t 10 devices in this basket, each device must

be a maximum of 28 mm or 1.1 inches thick. Place your device here. If the device ts within the black boundaries,

go to STEP 2.