Jabra Engage 75 Stereo Operating instructions

Brand: Jabra

Model: Engage 75 Stereo

Type: Operating instructions

Jabra Engage 75 Stereo

How do I use the conference call mode with my Jabra Engage

75?

You can set up a conference call with the Jabra Engage 75 by pairing up to

three additional headsets with the same base. You can pair a headset

“over the air” or dock it in the base. If you dock a headset in the base, the

headset must have the same docking interface as the base. For example, a

Jabra Engage mono headset and a Jabra Engage mono or stereo base.

Add headset(s) using the base

Jabra Engage 75 base with touch-screen display:

1. Undock the primary headset.

2. Dock an additional headset in the base.

3. Tap to add the headset as an additional headset.

4. When the headset has been successfully paired with the base, a voice

prompt is announced in the primary headset. Press the Call button on

the primary headset to accept the additional headset. The audio is then

shared between headsets, which are muted by default.

08/09/2023 16:20

https://www.jabra.hk/supportpages/jabra-engage-75/9559-583-117/faq/fb26056d-

2493-4f72-92da-832803232087

Page 1 of 2

Add headset(s) without the base (pair over the air)

Jabra Engage 75 base with touch-screen display:

1. Tap on the base to open the Settings menu and navigate to Add

headset.

2. Tap to switch to Pair without docking.

3. Tap to put the base into pairing mode.

4. Turn off the additional headset by holding the Call button for 4

seconds.

5. Put the additional headset into pairing mode by holding the Call

button for 5 seconds until the LED flashes blue. The base and the

headset will attempt to pair.

6. A voice prompt will play in the primary headset to indicate the

additional headset has been paired with the base. Press the Call button

on the primary headset to accept the additional headset and complete

the pairing. The audio is then shared between headsets, which are

muted by default.

End or leave a conference call

To end the call for all headsets, press the Call button on the primary

headset or dock the primary headset in the base. Additional headsets can

leave the conference by pressing the Call button on the headset or by

docking the additional headset in the primary headset base (not the

additional headset base). The conference call will continue for all other

headsets.

Permanent conference mode

By default, the conference will end automatically for all additional

headsets when the call ends. To continue the conference with the

additional headsets until the primary headset is docked, change this

specific setting in Jabra Direct.

08/09/2023 16:20

https://www.jabra.hk/supportpages/jabra-engage-75/9559-583-117/faq/fb26056d-

2493-4f72-92da-832803232087

Page 2 of 2

Jabra Engage 75 Stereo Operating instructions

Jabra Engage 75 Stereo Operating instructions

Jabra Engage 75 Stereo Operating instructions

Related papers

Other documents