2. Malco
  3. Gutter Outlet Punches

Malco Gutter Outlet Punches, GOT Operating instructions

  • Hello! I've reviewed the provided document, which contains instructions for replacing the chock in a GOT tool. The instructions detail the steps, including removing and reinstalling the blade, drive rod, and chocks, while also providing guidance on dealing with the springs. I'm happy to answer any questions you have about the chock replacement process
  • What is the first step in replacing the chocks?
    What should you do after removing the blade assembly?
    What should you do with the springs while replacing the chocks?
1. Remove blade assembly mounting bolt to
disconnect blade assembly from drive rod.
(Avoid damaging blades).
2. Pull drive rod out of tool through top.
3. Remove release chocks and drive chock,
(the springs will be loose). Replace drive
chocks and release chock while holding
the springs in position.
4. Insert drive rod through top slot and work
it through the chocks and springs and
through bottom slot.
5. Connect blade assembly to drive rod.
GOT
CHOCK REPLACEMENT INSTRUCTIONS
Top Slot
Release
Chock
Drive Rod
Springs
Drive
Chocks
Bottom
Slot
Blade
Assembly
Mounting
Bolt
Malco Products, SBC | Annandale, Minnesota, U.S.A. | www.malcotools.com | ©2019
U.S. 320-274-7387 - 800-328-3530 | Canada: 320-274-2376 - 800-219-1085 |
International: 01-320-274-2376
SL10684C
/