1
Functionality added in M-300 version 1.05
User Settings
●
“MAIN FADER” option has been added to the USER PREFERENCE popup.
If you check “SENDS ON FADER MASTER”, the MAIN fader becomes the send-destination AUX/MTX master fader, while the SENDS ON FADER is on.
●
“SYSTEM SETUP” in the USER LEVEL popup also disables S-4000M CONFIGURATION operation.
●
[F6 (PREV FADER)] and [F7 (NEXT FADER)] have been added to the USER FADER ASSIGN popup.
●
[F6 (PREV BUTTON)] and [F7 (NEXT BUTTON)] have been added to the USER BUTTON EDIT popup.
Other Improvements
●
Now you can use the SENDS ON FADER function to adjust the send level from AUX buses to a MTX bus.
●
Now the GEQ ON FADER function does not cancel the SENDS ON FADER.
●
A “0.5dB STEP” option has been added to the GEQ EDIT popup.
If this is checked, the GEQ fader operation will step by 0.5 dB.
●
The Auto MDI/MDI-X function has been added.
This function automatically detects the type of the connected Ethernet cable (Crossover or Straight) and configures the connection appropriately.
By enabling this, both Crossover and Straight Ethernet cable can be supported for REAC connection.
1.
In the SETUP section, hold down [SYSTEM] and turn the power on.
The SYSTEM CONFIG screen will appear.
M-300_v105Added_e.book 1 ページ ２０１１年４月１１日 月曜日 午前９時１８分
2
Functionality added in M-300 version 1.05
2.
Press [F4 (REAC)].
The REAC popup will appear.
3.
Press [ENTER] to check “Auto MDI/MDI-X”.
4.
Press [F8 (OK)].
5.
Turn off the power.
1PS
M-300_v105Added_e.book 2 ページ ２０１１年４月１１日 月曜日 午前９時１８分
-
1
-
2
