10
in.chant
TM
Important note:
This unit must be supplied by a
+12Vdc Limited Power source
certified to UL 1585-3, Class 2
Wet or certified to UL/IEC/EN
60950-1.
Red Wire
Connect this wire to a constant
+12V power source.
Yellow Wire (w/fuse)
Connect this wire to a constant
+12V power source.
Black Wire
Connect this wire to the ground
of the power source.
Blue Wire (w/fuse)
Connect this wire to the (+)
power antenna activation
circuit. If no power antenna
exists, tape off the end of this
wire to prevent shorting out of
the unit.
White wire
Connect this wire to the left
front speaker (+) positive
terminal or wire.
White wire with Black stripe
Connect this wire to the left
front speaker (-) negative
terminal or wire.
Grey wire
Connect this wire to the right
front speaker (+) positive
terminal or wire.
Grey wire with Black stripe
Connect this wire to the right
front speaker (-) negative
terminal or wire.
Green wire
Connect this wire to the left rear
speaker (+) positive terminal or
wire.
Green wire with Black stripe
Connect this wire to the left rear
speaker (-) negative terminal or
wire.
Purple wire
Connect this wire to the
right rear speaker (+) positive
terminal or wire.
Purple wire with Black stripe
Connect this wire to the
right rear speaker (-) negative
terminal or wire.
Notes:
This unit is designed to connect
4 speakers: If the installation
requires only 2 speakers, use
the white and grey wire sets to
connect the speakers.
WARNING
Any wires left unconnected
must be taped off or capped off
to prevent shorting.
DO NOT connect speaker
ground wires together.
DO NOT connect speaker
ground wires to the chassis or
to the power supply ground.
DO NOT connect front and rear
speaker wires together.
FAILURE TO FOLLOW ANY
OF THESE WARNINGS WILL
RESULT IN DAMAGE TO
THIS UNIT AND VOIDS THE
WARRANTY.
connections