FAILURE TO COMPLY WITH THE FOLLOWING WARNINGS MAY SIGNIFICANTLY SHORTEN
THE PRODUCT’S LIFE TIME, AND LEAD TO FAILURES AS WELL AS HAZARDOUS
CONDITIONS*. COMMON SENSE MUST ALWAYS PREVAIL WHEN EVALUATING THE
INSTALLATION AND/OR USE OF ANY ELECTRONIC CONTROL IN A FINAL APPLICATION.
• The maximum ambient conditions this PRODUCT is subjected to (temperature, humidity,
etc.) are not to be exceeded.
• This PRODUCT must be installed by a qualified personnel.
• Only qualified personnel are to service this PRODUCT. There are no user serviceable
parts inside.
• This PRODUCT is only compatible with Aeware's® in.tune™ products.
• This PRODUCT should be installed on a clean flat surface.
• The gasket on the back of the unit will prevent water infiltration inside, behind the
mounted surface. If the gasket is damaged, the user must seal the back of the unit with
silicone to avoid any leakage behind the mounted surface.
* HAZARDOUS CONDITION: A condition that is potentially damaging and/or dangerous to
its operator or surroundings. This includes, but is not limited to: fire, flooding or other
water damage, dielectric breakdowns (presence of high voltage), etc.
Warnings:
in.K175
™
AEWARE AUDIO/VIDEO KEYPAD
Radio models supported by in.k175™ are:
• Aeware® in.tune™ / in.tune.110™
receiver model.
• Aeware® in.pix™ audio/video model.
Compatibility:
• 3.58 (Length) by 2.15’’ (Width) by
0.20’’ (Height).
• Soft gasket
Mechanical Specs:
• Humidity: Up to 95 %
condensing
• Operating temp.: -20 to 50˚C
• Storage temp.: -30 to 70˚C
Environmentals:
• IP rating IPX5
• UV resistant
• UL 1563
• CSA C22.2 No.218.1
Standards:
Wiring Diagram: Drilling template:
Male to male 8-pin mini din cable
(supplied with wired remote)
Wired remote
in.k175™
in.tune
or
in.pix
• To install the in.k175™, use the
drilling template to cut the surface,
peel off the backing paper of the
adhesive and stick the in.k175™ on
the surface.
(see illustration)
Installation:
• scale 1 : 1
3.58 "
2.15 "
1.35 "
2.78 "
Cut along
Dashed line