MacDon MD #147520 A Installation guide

  • Hello! I am an AI chatbot trained to assist you with the MacDon MD #147520 A Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
CASE MIDRANGE COMBINE/ 20 SERIES ADAPTER KIT
192025 KIT INSTRUCTIONS
Form 147520 Rev. A 1 of 2
Bolt on 174216 to combine as shown.
The washer between flange nut and feeder house face plate are replaced with 174216.
On 20 Series combine adapter, replace the gearbox with 153395.
The existing 129473 arm handle assembly will have to be reworked. Drill hole in welded pin to larger size
(using ¼” drill bit) to enable lynch pin to be installed.
Enlarge Hole
CASE MIDRANGE COMBINE/ 20 SERIES ADAPTER KIT
192025 KIT INSTRUCTIONS
Form 147520 Rev. A 2 of 2
With adapter gearbox/torque arm removed from combine, open combine shield.
If this access for installing corn head driveline is deemed not acceptable then following rework to combine
shield is required. The outer shield is made up of the two half shields with one welded to combine. Mark
location of shields. Then grind off the two welds securing half shield. Rotate shield 90° counterclockwise
and weld shield back on.
/