Wind ‘N Go

®

TimeMinder™ #7600

IMPORTANT SAFEGUARDS

• Read all instructions before operating

• Do not look directly at the light; may cause injury

• Do not use in flammable or explosive environments

• Do not operate at temperatures above 120°F

• Avoid placing siren near the ears when using the siren

• To reduce the risk of electric shock, do not submerge the unit or its accessories in any liquid.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of more of the

following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help

Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must

Dynamo Charging:

1.

Open the HAND CRANK and rotate steadily clockwise at approximately 120 cycles/minute for a minimum of

one minute. Longer wind-up times will yield a longer power duration. The blue backlight will appear on the LCD

DISPLAY during charging.

2. Close the

HAND CRANK

.

USB Charging:

1. Slide the CHARGING SELECTOR switch on the back of the unit to the left under TimeMinder icon.

2. Plug the INPUT/OUTPUT ADAPTER (the longer cord) into the OUTPUT/INPUT jack on the top of the unit and

plug the USB connector into a USB port of your computer or into a universal 5 volt DC USB charging device. The

blue backlight will appear on the LCD display during charging. NOTE: Only use a 5V USB power supply. Higher

OPERATION

Setting the Time and Alarm:

1. To set the time, press and hold the TIME SET button while pressing the HOUR and MINUTE buttons until

the correct time is displayed.

2. To set the alarm time, press and hold the ALARM SET button while pressing the HOUR and MINUTE

buttons until your desired AM or PM alarm time is displayed.

3. To activate the alarm, press the ALARM ON/OFF button. An alarm clock icon will appear in the LCD

display to indicate that the alarm is activated. When the alarm goes off, the backlight will appear to display

the alarm time in the LCD screen. Press the ALARM ON/OFF button one time to turn off the alarm. The alarm

clock icon will continue to appear in the LCD display and is still set to go off at the same time the next day.

station will appear in the LCD screen.

2. Select either the AM or FM band using the function switch on the top and tune to the desired station by

turning the TUNING dial.

Backlight: The backlight appears during charging, when the alarm goes off, or when the time/alarm or radio

functions are set. NOTE: To activate the backlight at any time, press the time set button.

3 LED Flashlight: Slide the LIGHT ON/OFF switch to the right or left for desired function.

Siren: Slide the function switch on the top to SIREN for a high-decibel emergency siren.

CELL PHONE CHARGING

1. Slide the CHARGING SELECTOR switch on the back of the unit to the right under the cell phone icon.

2. Plug the OUTPUT/INPUT ADAPTER, (the longer cord) into the OUTPUT/INPUT jack on the top of the unit

cell phone.

only available with

wind-up

AM 525 - 1710 Khz

FM 88 - 108 Mhz