CURT 12110 Installation guide

Type
Installation guide

This manual is also suitable for

CURT 12110 is a weight-carrying hitch designed for Toyota Camry Solara vehicles. It has a gross load capacity of 3,500 lbs. and a tongue weight of 300 lbs. The hitch is designed to be used with ball mount # D-221 / 45522 and has a hitch weight of 40 lbs. It can be installed in approximately 45 minutes and does not require any drilling. The hitch comes with all necessary hardware, including 5 M10 - 1.25 x 30 hex bolts and 5 3/8" conical toothed washers.

Here are some possible use cases for the CURT 12110 hitch:

  • Towing a small trailer or camper
  • Carrying a bike rack or cargo carrier
  • Mounting a snowplow or other attachments

CURT 12110 is a weight-carrying hitch designed for Toyota Camry Solara vehicles. It has a gross load capacity of 3,500 lbs. and a tongue weight of 300 lbs. The hitch is designed to be used with ball mount # D-221 / 45522 and has a hitch weight of 40 lbs. It can be installed in approximately 45 minutes and does not require any drilling. The hitch comes with all necessary hardware, including 5 M10 - 1.25 x 30 hex bolts and 5 3/8" conical toothed washers.

Here are some possible use cases for the CURT 12110 hitch:

  • Towing a small trailer or camper
  • Carrying a bike rack or cargo carrier
  • Mounting a snowplow or other attachments
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3,500
300
40
45
12110 TOYOTA CAMRY SOLARA
10/8/2012
Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLTM10 - 1.25 x 3051
CONICAL TOOTHED WASHER3/8"
52
2
1
1. If present, remove the tie down brackets and bolts from each side of the vehicle's frame rails. Return these
brackets and fasteners to the vehicle's owner.
NOTES: On vehicles with exhaust hanger bracket welded to passenger's side tie down bracket, the
tie-down / exhaust hanger will be reattached with the hitch in step #3.
2. Remove the exhaust hanger bolted to the bottom of the frame rail on the passenger side. Return fasteners
to the vehicle's owner. There is no need to remove the exhaust hanger from the rubber isolator.
3. Raise the hitch into position and install (5) 10mm bolts and conical toothed washers as shown. Install the
bolts and conical toothed washers through the exhaust hanger bracket on the passenger's side frame rail
as shown.
4. Torque all 10mm fasteners to 48 lb-ft.
NO DRILLING REQUIRED
10/8/2012
DESIGNED FOR USE WITH
BALL MOUNT # D-221 / 45522
  • Page 1 1

CURT 12110 Installation guide

Type
Installation guide
This manual is also suitable for

CURT 12110 is a weight-carrying hitch designed for Toyota Camry Solara vehicles. It has a gross load capacity of 3,500 lbs. and a tongue weight of 300 lbs. The hitch is designed to be used with ball mount # D-221 / 45522 and has a hitch weight of 40 lbs. It can be installed in approximately 45 minutes and does not require any drilling. The hitch comes with all necessary hardware, including 5 M10 - 1.25 x 30 hex bolts and 5 3/8" conical toothed washers.

Here are some possible use cases for the CURT 12110 hitch:

  • Towing a small trailer or camper
  • Carrying a bike rack or cargo carrier
  • Mounting a snowplow or other attachments

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI