Salsbury Cell Phone Locker Pedestal Installation guide

Type
Installation guide
SALSBURY INDUSTRIES
18300 Central Avenue, Carson, CA 90746-4008
Phone: 1-800-624-5269 Int’l Phone: 323-846-6700
Fax: 1-800-624-5299 Int’l Fax: 323-846-6800
www.lockers.com www.mailboxes.com engineering@mailboxes.com [email protected]m
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2020 Salsbury Industries. All rights reserved. 4/8/2013 Page 1 of 1
Cell Phone Locker Pedestal
For Select 19000 Series Surface Mounted Cell Phone Lockers
Installation Instructions
Installing the Cell Phone Locker on the Pedestal
Step 1: Install the pedestal to the mounting surface. Use 1/2 in. diameter
anchors (not provided).
Step 2: Remove the cell phone locker from the enclosure. Drill eight (8)
7/16” diameter holes through the bottom of the enclosure. Match the hole
locations on the top pedestal plate.
Step 3: Position the enclosure on the top pedestal plate then position the
interior support plate inside the enclosure. Assemble to the pedestal by
installing 3/8”-16 x 1-1/2” long hex bolts (provided) through the top pedestal
plate, through the bottom of the enclosure and through the interior support
plate. Fasten with 3/8” lock washers and hex nuts (provided).
Step 4: Install the cell phone locker into the enclosure by sliding it into the
enclosure until its front peripheral flange is flush against the front of the
enclosure. Open the four corner compartments of the cell phone locker.
Install #8 x 1-1/4 long screws (provided) through the top and bottom of the
locker unit into the enclosure. Close the compartment doors.
  • Page 1 1

Salsbury Cell Phone Locker Pedestal Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI