Haunted Hill Farm FSHLJK018A-OR1 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Haunted Hill Farm FSHLJK018A-OR1 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
I. Diagram
II. Component list
No.
Name
Number
1
Lamp pendant
1
2
Lamp
1
3
Hold-nut
1
4
Hanging Chain
1 (59in)
5
Expansion tube + hook
1
6
Power wire
1 (11.5ft)
7
Adapter (12V AC 500mA)
1
Note
1, 2, 3 and 4 are power cable joints
III. Installation steps
Please install according to the figures and steps below:
A. Installation positioning
It is suggested to hang the lamp 70 in. above the
floor to get the best view angle.
B. Fix the hook: Drill a hole on the ceiling above the
lamp to install expansion tube + hook (part #5);
C. Install hold-nut: Spin and fasten the hold-nut (part #3)
on the top of the lamp (part #2). Note: The hanging
chain (part #4) is already tied together with the
hold-nut; please make sure to fasten the hold-nut in
case it gets loose and falls down.
D. Connect power wire to the lamp: Insert the plug (2)
of the power wire (6) to the jack (1) on the top of the
lamp (2).
E. Hang lamp and arrange power wire: Hang the
hanging chain (4) and power wire (6) that have
already been fixed on the lamp (2) to the hook (5). You
can adjust the length of the chain according to the
distance between the lamp and the ceiling.
F. Power on: Connect the joint (3) of the power wire (6)
with the joint (4) of the adapter (7) and then connect
the adapter with the main power source.
G. Examination: When setting the switch on the bottom
of the lamp (2) (see the small figure under) to the left
side to start it, the lights in the lamp should light up,
motion should be active and music will start. If it fails to
perform such functions, it is necessary to check if the
joints 1, 2, 3 and 4 are well connected. You can also
turn the switch to the right side to turn off the music.
H. Install lamp pendan
t: Spin the lamp pendant (1) to
fasten it with the lamp (2);
I. Adjust direction: You can adjust the direction of the
lamp by spinning the direction of the hook (5) to your
satisfaction.
Caution
This product is fragile and should be assembled
with care.
Please follow the below steps and requirements
specified in the instruction to ensure safety and
reliability during the installation.
Be sure to fix it on the ceiling securely.
The product is not water proof, do not use it
outdoors.
/