27 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 834956
834956 ProClip
Console mount, ONLY for automatic transmission.
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288349565
Item no 834956 fits:
Toyota Corolla 14-15 (For USA)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read the instructions and look at the pictures carefully before installing the ProClip.
1. Place/align the wide end of the enclosed gap opener with the edge of the panel surrounding the gear shift to
create the light location for attaching the ProClip.
2. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the adhesive tape
cover on the ProClip. Press/hook the angled edge on the left side of the ProClip into the seam between the shifter
frame and the floor console upper panel edge in front of the gap opener.
3. Press the thin end of the gap opener info the gap in the console sidewall next to the ProClip, to widen the gap.
Press down on the top right side of the ProClip so it flexes downward. The lower angled edge on the ProClip
should hook into the gap next to the gap opener. Pull out the gap opener.
4. The ProClip is in place.
2(2)
/