Feiss F3224 Installation guide

Feiss
Brand
Feiss
Model
F3224
Type
Installation guide

This manual is also suitable for

1
Installation Instructions for
Patrice Island
1.0
F3224-6
Chandelier
F3224/6
1
2
1A
3
4
5
Temporarily install the mounting plate to the junction box, mark the anchor hole locations, and remove the mounting plate.
Drill appropriate size holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box.
Screw the anchor screws into the anchors.
Determine the wanted height of the fixture with the provided stems and swivels and assemble them by screwing them together. Then
secure the swivels to the canopy with the provided canopy plate, washers, and hex nuts in the order shown.
Feed the cord through the stem, canopy, and out of the electrical box. Trim the cord leaving enough to make electrical connections.
Screw both stems to the top of the fixture.
Connect the fixture to a suitable ground with accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box and/or canopy, place the canopy onto the mounting plate studs, and secure it in place
by using the cap nuts.
Install the candle tubes by sliding them over the sockets.
Install the candle followers by placing them on top of the candle tubes.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.
6
7
8
9
10
11
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
MOUNTING PLATE
HEX NUT & WASHERS
CANOPY
STEM ASSEMBLY
CANOPY PLATE
CAP NUT
LAMP
CANDLE TUBE
CANDLE FOLLOWER
5
7
14
13
12
SWIVEL
ANCHOR
ANCHOR SCREW
WASHER
7
12
13
14
Page is loading ...
Page is loading ...
4
7400 Linder Ave, Skokie, 160077IL
800.969.3347
www.Feiss.com
© 2018 Feiss.All rights reserved.The "Feiss" graphic is a
registered trademark of Feiss. Feiss reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Feiss F3224 Installation guide

Feiss
Brand
Feiss
Model
F3224
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents