Greenlee 52042654 UT2 Cage User manual

SERVICE INFORMATION

52042654

UT2 Cage Service Kit

Mounting Instructions

Use the templates to drill mounting holes in the UT2

frame for the motor cage:

Use the small templates to locate and drill four 17/64"

dia. holes on the top and bottom of the frame.

Drill a fth 17/64" hole on the right side of the frame

using the large template. Drill a #20 (0.161" dia.) hole

in front of the other hole.

Fit the cage to the frame as shown:

Insert the forward leg through the 17/64" hole in the

side of the frame. Secure this leg with the #10 self-

tapping screw.

Attach the back of the cage with the four 1/4-20 hex

head screws and nuts.

•

Important Safety Information

Wear eye protection when performing

this procedure.

Failure to wear eye protection could

result in serious eye injury from ying

debris.

Parts List

Part No. Description Qty

52033800 Cage weldment ............................................

90500598 Screw, 1/4-20 x 1/2 ......................................

90521080 Nut, 1/4-20 hex ............................................

90531949 Screw, #10 self-tapping ...............................

52042655 Templates .....................................................

52042656 Mounting instructions ..................................