SERVICE INFORMATION
52042654
UT2 Cage Service Kit
52042656 © 2008 Greenlee Textron Inc. 5/08
Mounting Instructions
Use the templates to drill mounting holes in the UT2
frame for the motor cage:
Use the small templates to locate and drill four 17/64"
dia. holes on the top and bottom of the frame.
Drill a fth 17/64" hole on the right side of the frame
using the large template. Drill a #20 (0.161" dia.) hole
in front of the other hole.
Fit the cage to the frame as shown:
Insert the forward leg through the 17/64" hole in the
side of the frame. Secure this leg with the #10 self-
tapping screw.
Attach the back of the cage with the four 1/4-20 hex
head screws and nuts.
•
•
•
•
Important Safety Information
Wear eye protection when performing
this procedure.
Failure to wear eye protection could
result in serious eye injury from ying
debris.
Parts List
Part No. Description Qty
52033800 Cage weldment ............................................
1
90500598 Screw, 1/4-20 x 1/2 ......................................
4
90521080 Nut, 1/4-20 hex ............................................
4
90531949 Screw, #10 self-tapping ...............................
1
52042655 Templates .....................................................
1
52042656 Mounting instructions ..................................
1