Quick Using Guide
1. Before turning on the camera, please insert a branded U3 high-speed Micro SD Card.
2. Plug into the power using the car charger we provided and please make sure to keep the
camera plugged into the power all the time
3. After plugging, the camera will turn on to record automatically, however. we suggest you
format the Micro SD Card on the camera before recording for the first time.
FQA
1. The Camera Displays "Memory Error".
A. Please make sure you used the branded U3 high-speed Micro SD card.
B. Please make sure to format the Micro SD card before recording.
C. Please format the Micro SD card to FAT32/exFAT on the computer.
2.The Camera Turns on/off by itself.
A.Please refer to the steps as the solution "Memory Error" first.
B.Please make sure the power supply is normal.
Please make sure Both functions "Motion Detection" and "Auto Power Off" are not enabled at
the same time.
3. How to access the setup interface?
Please stop the recording first, then access the Setup interface. otherwise. cannot access it.
4. Why the camera cannot start recording
after powered on?
A.Please reset the camera manually.
B. Please re-format the Micro SD card on the camera.
Tips:
1.The voltage of the car cigarette lighter is 12-24V, and the rated voltage of our dash cam is 5V, so
we need to use the car charger in the packaging to turn the vehicle voltage into 5V to ensure that
the driving recorder is normal charging . Otherwise, the car Camera will insufficient power supply,
which will cause the car camera to not be bright enough, the screen flash, and poor
contact,automatic shutdown, etc .
2.If you want to achieve 7*24h parking monitoring function, need to contact the LAMTTO
support team to purchase a dedicated hardware kit.
3. The length of the original cable for the rear camera is 24 feet, suitable for most types of cars.
Please reach out to get an extended cable if you need it.
4. Please FORMAT the micro SD card in the dash camera before first use. Class 10, U3 Speed