2. Computers & electronics
  3. TVs & monitors
  4. Flat panel desk mounts
  5. Atdec
  6. AW-FB

Atdec AW-FB Installation guide

  • Hello! I have reviewed the provided installation guide for the Ora AW-FB Bolt Through Fixing. This document details the necessary steps for installing the product, including required tools and compatible desk sizes. I'm ready to answer any questions you have about the installation process or product details.
  • What size drill bit is needed for installation?
    What is the minimum hole size needed?
    What desk thicknesses are compatible with this product?
AW-FB Page 1 of 2
Installation Guide
AW-FB
Ora Bolt Through Fixing
COMPONENT CHECKLIST
A
Clamp Plate
(x1)
B
Clamp Bar
(x1)
C
Arm Spigot
(x1)
D
M8 Stud Bolt
(x1)
E
M8 Flange Nut
(x1)
REQUIRED TOOLS
• 4mm Hex key (supplied
with Ora arm)
• 8.5mm (or 12”) drill bit
• Power Drill
• 13mm Spanner
IMPORTANT INFORMATION
! Please ensure this product is installed as per these installation instructions.
! The manufacturer accepts no responsibility for incorrect installation.
! This product is compatible with Atdec Ora products.
! The product is compatible with grommet hole sizes from 60-80mm.
! The product is compatible with desk thicknesses from 0-55mm.
AW-FB Page 2 of 2
3. Attach plate assembly to desk
Place Clamp Bar B over M8 Stud Bolt D under the desk as illustrated
and secure Flange Nut E with spanner.
2. Attach Arm Spigot to Clamp Plate
TIP: Hold Arm Spigot C and Clamp
Plate A together, locating the
dimple in the slot, before hand
tightening the screw into the spigot.
2.2 Tighten rmly with 4mm
Hex Key supplied with Arm.
4. Install Monitor Arm onto Fixing
1. For bolt through installations, drill hole in work surface
1.1 Mark out hole
position on the
work surface. Use
Clamp Plate A as a
template.
1.2 Drill the hole using a suitable drill bit. Ensure the hole is
drilled perpendicular to the work surface.
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specications without notice. ©20230414
USER
Continue installation per Ora Monitor Arm
installation guide.
AW-ORA-F
8.5 mm
(12”)
40mm (1 ”)
minimum
TIP: Support plate while tightening to maintain
the correct orientation on the work surface.
2.1 Screw M8 Stud Bolt D through Clamp Plate A
into Arm Spigot C.
/