Stemedu Stemedu ESP32-CAM ESP32 OV2640 Camera User manual

www.diymalls.com [email protected]

ESP32-Cam

You can use serial module to program the ESP-Cam, such as CP2102 module, CH340

module, FTDI programmer, FT232RL programmer etc.

Connection:

GPIO0 pin need to be connected with GND(green cable in the picture)

When uploading the code, it shows connecting_connecting_...please press RST button once

After program is finished, please disconnect the cable between GPIO 0 and GND

Reference Tutorial links:

www.diymalls.com [email protected]

How to Program / Upload Code to ESP32-CAM AI-Thinker (Arduino IDE)

https://randomnerdtutorials.com/program-upload-code-esp32-cam/

ESP32-CAM Take Photo and Display in Web Server:

https://randomnerdtutorials.com/esp32-cam-take-photo-display-web-server/

Note: After programmed, please disconnect the cable between GPIO 0 and GND

Then you will see the print information once you open the serial monitor window

ESP32-CAM Troubleshooting Guide: Most Common Problems Fixed:

https://randomnerdtutorials.com/esp32-cam-troubleshooting-guide/

ESP32 projects:

https://randomnerdtutorials.com/projects-esp32-cam/