Premier Mounts PP-17 Operating instructions

Category
Projector mounts
Type
Operating instructions
PP-17
Step 1
Locate the 16” center studs. Level and mark with a pencil the six(6) mounting point
found on the bracket. Drill ¼” pilot holes into the marked points Then secure the bracket
with the six(6) 5/16” Lag Bolts and washers (supplied) to the ceiling.
Step 2
Slide the four(4) Step bolts on the secured plate. Secure the top portion of the base box to
the step bolts. Select proper position (Do not exceed more than 7” off center) using nuts
and washers. (Do not over tighten). Install the bottom portion of the base box to the
secured top using the six(6) 10/32 Phillip screws.
Step 3
Loosely install the spacer, Flat washer, and the two(2) 6mmx12mm Slottes hex bolt the
base box. Raise the projector with the secured mounting bracket slip it though the hinge
pins. Select the proper angle and secure it with the two(2) 6mmx12mm Slotted Hex bolts
(supplied). Than tighten all hardware.
A. 16” CENTERS STUDS
B. PP-17 CEILING PLATE
C. FLAT WASHERS
D. 5/16”X2-1/2” LAG BOLTS
E. STEP BOLTS
F. BASE BOX (upper portion)
G. FLAT WASHERS
H. FLAT WASHERS
I. NUTS
J. BASE BOX (bottom portion)
K. SPACER
L. PROJECTOR
www.touchboards.com 205 Westwood Ave.Long Branch, NJ 07740 1-866-942-6273 [email protected]
The ceiling should be capable of supporting a weight of at least five (5) times the
projector(s) or monitor(s)weight. If it cannot, the ceiling must be reinforced. Proper
installation procedure by qualified personnel as outlined in the installation instructions
must be adhered to. Failure to do so could result in serious personal injury.
For further information or ordering assistance
contact us at the phone/address number shown
on the front of this page.
  • Page 1 1
  • Page 2 2

Premier Mounts PP-17 Operating instructions

Category
Projector mounts
Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI