Martec MBHU1LW Operating instructions

Brand: Martec

Model: MBHU1LW

Type: Operating instructions

UNO 275W Single Lamp Heater Installation Guide

Thanks for choosing our UNO series..

We strongly recommend that you read this manual carefully before installation.

E: [email protected] | P: 02 8778 7500

www.martecaustralia.com.au

Model Parameter:

MBHU1LW 275W Single Lamp Heater White

Part List

Qty 1x Single lamp heater

Qty 1x 275W radiant heat lamp

Voltage 220V-240V 50Hz

Rating 275W max

Hole cut-out 145mm(6”)

Dimensions Dia 180mm

Projection below ceiling 25mm

Projection above ceiling 214mm

Specications

NB: The single lamp heater is designed for installation in the ceiling of

toilets and bathrooms. It provides both light and heat. Two or more

heaters may be required for large bathrooms.

•Attractive, ush tting units that scarcely protrude below the

ceiling

• Allows installation where the heat is required; above the

drying area or above the vanity or elsewhere depending on

the bathroom layout

• A semi-gloss white powder-coated rim surrounding the

incandescent mirror reector

Features

Wiring Diagram

Wiring

Remove cover from terminal

block.

Fg.1

Insert active, neutral and

earth wires and tighten the

terminal screws.

Fg.2

Replace cover from terminal

block.

Fg.3

E: [email protected] | P: 02 8778 7500

www.martecaustralia.com.au

WARNING Installation MUST carry out by a qualied and licensed electrician.

WARNING

• Installation of product MUST follow SAA standards and meet local authority regulations.

• Installation MUST be carried out by a qualied and licensed electrician.

• Warranty will be VOID if the unit has been tampered with damaging by accident, short circuited, loaded beyond rating or

damaged otherwise by improper operation.

• The warranty is VOID if product is not installed according to this installation guide.

2 Year In Home Warranty

Visit our website for details https://www.martecaustralia.com.au/warranty-statement/

How to Install

Step 1. Inspect ceiling cavity to ensure that electrical sub circuit wiring, water pipes and other services as well as ceiling timbers

are well clear of the intended position of the single lamp heater.

(NB: Ensure there is sucient clearance above the terminal block housing for two storey house.)

Step 2. Use template provided to cut a circular hole with a diameter of 145 mm.

Step 3. Remove packaging before installation.

Step 4. Connect cables .

Step 5. Be sure to replace the cover over the terminals.

Step 6. Insert the light bracket into the hole.

Step 7. Loosen the nut and move the bracket supplied to x the light rmly into place. Tighten the nut.

Step 8. Replace the reector cone and the lamp.

Aust/NZ Approval No.

SAA-210966-EA

Martec MBHU1LW Operating instructions

Martec MBHU1LW Operating instructions

Martec MBHU1LW Operating instructions

Related papers

Other documents