SHAW DIGITAL BOX
INSTALLATION INSTRUCTIONS
(Approx. Hardware Setup Time: 10-15 Minutes)
STEP 1
|
DO YOU HAVE EVERYTHING?
The following components are included in the package that your Digital box came in:
Cable Cord (Coax) Power Pack RCA Cables
Shaw Remote
STEP 2
|
TIME TO HOOK UP YOUR NEW HARDWARE.
B. Find a location to put your new hardware that will allow
it to breathe.
C. Screw one end of the
included white cable cord
(with silver ends) in to your
wall cable outlet and the
other end in to RF IN on
the back of the Digital box.
For an optimal viewing
experience, we recommend
using the included cable
cord instead of any others
that you might have around.
A. Your serial number, “SN,” is located on the back of the
Digital box (next to RF IN) and starts with the letter “M”.
You will also need your Shaw account number, which
can be found in the top right hand corner of your Shaw
invoice.
Before your hook up your Digital box, write your serial
number and account number below. You will need it
when you activate your new hardware.
Wall Outlet
Cable InCable Out
Serial Number:
Account Number:
Motorola DCT 700
D. Connect the included RCA/AV cable (black cable with
red, yellow and white ends) from the Digital box to
your TV. Both video and audio travel through RCA/AV
cables. Note the input you plugged the cables into on
the back of your TV (i.e. Video 1, Video 2, etc.).
E. Connect the included power pack from the wall power
outlet to the Digital box.
RCA In
RCA out
Television
Power Pack
STEP 3
|
NOW WE JUST NEED TO GET YOUR BOX ACTIVATED.
A. Turn on your Digital box by pressing the CABLE power button, located in the top right hand corner of the included
Shaw remote. An amber light on the front of the Digital box will display when the power is on.
B. Tune your TV to the video input (i.e. Video 1, Video 2, etc.) that you plugged the Digital box into in step 2-D.
C. Activate your Digital box online by visiting SHAW.CA/ACTIVATIONS. Make sure you have your serial number and
account number ready.
If you do not have Internet access, or need additional help, please call us at 1.888.270.2433
D. To program your Shaw remote to work with your TV (adjust volume etc.), follow the “Quick Setup” instructions on the
reverse of the remote or visit www.urcsupport.com/shaw.
Note: Once your Digital box is activated it may take a few minutes for your on-screen programming guide to display and
up to 30 minutes for program information to load.
SD_INSTALL_SEPT12
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Shaw ATLAS PVR Universal Remote Control User manual
-
-
Winegard SK-7003 Mount Installation guide
-
-
-
-
-
Toshiba 55VX700U Owner's manual
-
CSI Fiberlink 3134 User manual
-
Almex T1 User manual
