3
3. Settings
Before recording, you can set up the device according to your requirements.
- In video/picture preview mode, press [MENU] to enter video/picture
sengs, press it again go the general sengs, press it third me to exit.
- In seng list, use
[ ]/[ ]
to navigate the menu, press [OK] to get the
opons and confirm the selecon, press [MENU] to exit.
Video settings
•
•
•
PICTURE SETTINGS
3
User Manual RoadRunner
527DL
Resoluon: Select the resoluon of recorded video: FHD 1920 x 1080, 720P 1280x720, WVGA 848 x
480.
Dual Recording: Off/On. Video recording from front and back cameras.
Loop recording: Set the video duraon (1, 3, 5 minutes or off) for loop recording. When the microSD
card is full, the device will delete the oldest unlocked video file automacally.
HDR: Off/On. Turn on or off High-dynamic-range. HDR can enhance the brightness in dark, and adjust
the brightness in backlighng.
White Balance: Auto, Daylight, Cloudy, Tungsten, Fluorescent. Select an appropriate white balance,
so images have a true-to-life color range. It is for specific lighng situaons.
Moon Detecon: Off, Low Level, Middle Level, High Level. Turn on or off moon detecon. If there
is any moon detected while the car engine is stopped, your car DVR will start recording
automacally.
Record Audio: Off/On. Set to record sound or not.
Date Stamp: Off/On. Add date stamp onto videos.
G-sensor: Off, Low Level, Middle Level, High Level. Select the sensivity of the G-sensor. The smaller
the number is, the higher the sensivity is. When reaching the sensive value (such as collision), the
recording file will be automacally protected.
Parking Mode: Off/On.
Select Camera: Front Camera, Back Camera, Front and Back camera, Back and Front Camera.
Capture Mode: Set the mer: Without mer, 2S Timer, 5S, Timer, 10 S mer.
Resoluon: Select the picture image size from 2MP, 1.3MP, VGA.
Sequence: Turn off/on photo sequence.
Quality: Set the photo quality Fine/Normal/Economy.
Sharpness: Adjust the sharpness Strong/Normal/So.
White Balance: Select an appropriate white balance, so images have a true-to-life color range. It is
for specific lighng situaons. Auto, Daylight, Cloudy, Tungsten, Fluorescent.
Color: Set the photo color Color/black&white/sepia.
ISO: Set the ISO Auto/100/200/400.
An-Shaking: Off/On.
Date Stamp: Off, Date, Date/Time. Add data stamp onto photos.