Noble House 301222 User guide

Type
User guide

This manual is also suitable for

Label Picture Description QTY
A Table Top 1
B Leg 4
Label Picture Description QTY
Washer 17
Bolt (M6*15) 17
Allen Key 1
Caution : You must read this before you proceed
Table
Before
Beginning
Assembly:
*17
*17
Page 1 OF 4
Step 1
Step 2
Overview
This Table has multiple parts and may require up to 30 minutes to assemble. To give
you an overview of the Table parts, the above picture is to help you put the various parts
into perspective. Please read through the instructions below to familiarise yourself with
the parts and steps before assembly.
Open the carton and place all the parts onto a clean, non-marring surface.
Place the Table Top(A) facedown onto the clean, non-marring surface.
Align the Legs(B) to Table Top(A) as shown in the picture.
Note: The point of the Legs corners should match with the Table Edges
Attach Leg(B) to Table Top(A) using Bolts() and Washers() with Allen Key() as
shown above.
Repeat the same process to install the remaining three Legs(B).
Do not fully tighten the Bolts.
Note: The point of the
Legs corners should
match with the Table
Edges
Note: The point of the
Legs corners should
match with the Table
Edges
Table Top(A)
Leg(B)
Page 2 OF 4
Step 3
Step 4
Place the Table on a LEVEL SURFACE to check for wobbles.
If it wobbles, apply even steady pressure down on the Table.
This action should help align all parts.
Then proceed to tighten all Bolts at all joints
Do NOT fully tighten a Bolt in one go and then move on to the next one.
Rather, in a sequential manner, gradually tighten each Bolt until all Bolts are
evenly secured.
This methodology will ensure maximum evenness once all Bolts are fully
tightened.
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Page 3 OF 4
Page 4 OF 4
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Noble House 301222 User guide

Type
User guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI