Manufactured by: Phone 717-825-2741
InterMetro Industries Corp. FAX 717-825-2852
North Washington Street For Product Information, call 1-800-433-2232
Wilkes-Barre, PA 18705 For Customer Service, call 1-800-992-1776
31.15
DIMENSIONS
Approx.
Height Width Length Pkd. Wt.
Cat. No. Finish (in.) (mm) (in.) (mm) (in.) (mm) (lbs.) (kg)
T68A Anodized Overall 46
3
/
4
1185 32
1
/
4
820 56 1420 108 49
Inside 38
1
/
4
970 30 760 50 1270
ACCESSORIES
Model
C8AIR Extra Heavy-Duty Pneumatic-Tired Casters†
C8D 8" (203mm) Heavy-Duty Rubber-Tired Casters
†NOTE: Wheel Brake not available on Pneumatic Casters.
Two swivel and two rigid casters.
SPECIFICATIONS
• Material: 14-gauge and 10-gauge high-strength silver anodized
aluminum.
• Construction: Aircraft-riveted construction throughout.
• Bottom: 10-gauge, brake-formed box shape, turned down and
sealed.
• Ends: 14-gauge, brake-formed, channel-shaped ends, riveted to
chassis.
• Doors: Single sheet 10-gauge with continuous hinge. Two-point
horizontal rod latch. Two doors, one side only, hinged at center,
top door swings down from top, bottom door swings up from
bottom. Door keeper holds bottom door in raised position. Top
doors, center-hinged, swing 180 degrees.
• Casters: 5" (127mm) two BB5N swivel, two BB5NR rigid double
ball-bearing swivel, ball-bearing axle, zinc-plated, pre-lubricated,
neoprene-tired, bolted through
1
/
8
" (3mm) flanged support plates
in a diamond pattern.
• Handles: Recessed tubular push handle at each end.
• Bumper: Continuous gray vinyl (A33) non-marking, fastened to
chassis.
NOTE: Corner mounting of casters available on request. Specify on order.