Hasbro Ride 2 Roll Scooter Operating instructions

Hasbro
Brand
Hasbro
Model
Ride 2 Roll Scooter
Type
Operating instructions

This manual is also suitable for

Hasbro Ride 2 Roll Scooter

This unique toddler toy offers 2 types of vehicle play. Use it as a ride-on or scooter! For growing toddlers, the RIDE2ROLL Scooter is a foot-to-floor ride-on that offers extra height and leg room. As your child grows steadier on his feet, this toy easily converts to a child’s first scooter that encourages balance, coordination, and timing. The easy-grip handlebars and maximum weight of 60 lbs (27.2 kgs) make this scooter perfect for both indoor and outdoor fun.

Hasbro Ride 2 Roll Scooter

This unique toddler toy offers 2 types of vehicle play. Use it as a ride-on or scooter! For growing toddlers, the RIDE2ROLL Scooter is a foot-to-floor ride-on that offers extra height and leg room. As your child grows steadier on his feet, this toy easily converts to a child’s first scooter that encourages balance, coordination, and timing. The easy-grip handlebars and maximum weight of 60 lbs (27.2 kgs) make this scooter perfect for both indoor and outdoor fun.

Ride2Roll
™
Scooter
Ride2Roll
™
Scooter
OVER 18 months
06717
© 2005 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
U.S. Patent Pending.
06717 P/N 6293990300
PLAYSKOOL.COM
FOR NEW PRODUCTS AND OFFERS
PLAYSKOOL.COM
FOR NEW PRODUCTS AND OFFERS
Questions? Call: 1-800-PLAYSKL
Thank you for buying this PLAYSKOOL brand product!
MAXIMUM WEIGHT
60 LBS. (27.2 KGS.)
CAUTION:
This product contains small parts which are necessary for assembly. Prior to
and during assembly of this product, keep small parts out of children’s reach. Small parts
pose a choking hazard to children under 3 years.
WARNING:
Always wear protective equipment including helmet, wrist guards, knee
pads and elbow pads (not included). Close-toed shoes or sneakers must be worn.
WARNING: TO AVOID SERIOUS INJURY:
Continuous adult supervision required; never use motor vehicles, near streets, swimming
pools, hills, steps or sloped driveways. Always wear shoes. Allow only one rider.
PLAY FEATURES
Easy-grip handlebars!
Parts include:
1 base, 1 end piece, 1 vehicle body,
4 wheels, 1 axle, 1 handlebar section, 1 top
handle, 2 labels, 1 bag of screws.
Adult assembly
required.
Keep the fun in high gear – in either mode!
Perfect for indoor or
outdoor fun!
ROUNDED SIDE FACING OUT
ASSEMBLY
RIDE-ON
SCOOTER
SMALLER
WHEEL
ATTACH
TO REAR
LATCH
BASE POST
TIGHTEN SCREWS
HANDLEBAR
SECTION
5. Attach Handlebar Section
As your child grows steadier on his feet, this
toy easily converts to a child’s first scooter
that encourages balance, coordination and
timing.
If the toy is in ride-on mode:
• Press latch on vehicle body and raise
vehicle body until it locks into place. Be
sure the word “LOCKED” appears on latch.
For growing toddlers, the RIDE2ROLL Scooter is
a foot-to-floor ride-on that offers extra height
and leg room.
If the toy is in scooter mode:
• Push latch on vehicle body downward and
bring vehicle body down until it locks into
place. Be sure the word “LOCKED” appears
on latch.
L
O
C
K
E
D
Pull out to convert to
SCOOT MODE
Push downward to convert to
RIDE-ON MODE
NOW YOU’RE READY TO ROLL OR RIDE…YOU DECIDE!
This unique toddler toy offers 2 kinds of vehicle play!
Use it as a ride-on or scooter!
Tighten screw into base post and handlebar arm.
Press latch on vehicle body, slide arm
of handlebar section through hole in
vehicle body, and snap handlebar arm
into post on base.
VEHICLE
BODY
4. Attach Wheels to Vehicle
Note: Be sure rounded side of wheels face out
when attaching to vehicle. Snap smaller wheels
onto rear of base. Snap larger wheels onto axle.
1. Place the RIDE2ROLL™ Scooter on the floor.
Position scooter on its side.
2. Snap each wheel firmly into place as shown.
You will hear a “click” once each wheel is properly
connected. This is a one-time assembly.
3. Once the wheels are snapped into place, test
each wheel by hand to make sure that it rotates
freely.
NOTE: If you have followed these steps and the
wheels do not rotate freely repeat steps 2 and 3
and apply more pressure to the wheels.
If wheels still do not spin freely after proper
assembly, call 1-800-PLAYSKL.
LARGER
WHEEL
ATTACH
TO AXLE
1.
2.
3.
Now you’re ready to roll!
Now you’re ready to ride!
RIDE-ON
ROLL-ON
6. Attach Labels
BASE
END PIECE
VEHICLE
BODY
TOP HANDLE
1. Attach End piece to Base
Fit end piece onto base. From underside of
base, tighten 2 screws into base and end piece.
Align
holes
AXLE
VEHICLE
BODY
AXLE
3. Attach Vehicle Body and Axle to Base
Fit vehicle body onto base (align holes in body with holes in base). Insert axle through holes.
From underside of vehicle, tighten screw into axle and base.
2. Attach Top Handle to Vehicle Body
Fit top handle onto vehicle body (align 3 tabs
on holder with slots on body). Tighten 6 screws
into top handle and vehicle body.
  • Page 1 1
  • Page 2 2

Hasbro Ride 2 Roll Scooter Operating instructions

Hasbro
Brand
Hasbro
Model
Ride 2 Roll Scooter
Type
Operating instructions
This manual is also suitable for

Hasbro Ride 2 Roll Scooter

This unique toddler toy offers 2 types of vehicle play. Use it as a ride-on or scooter! For growing toddlers, the RIDE2ROLL Scooter is a foot-to-floor ride-on that offers extra height and leg room. As your child grows steadier on his feet, this toy easily converts to a child’s first scooter that encourages balance, coordination, and timing. The easy-grip handlebars and maximum weight of 60 lbs (27.2 kgs) make this scooter perfect for both indoor and outdoor fun.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents