2. HECKLER
  3. H583

HECKLER H583 User guide

  • Hello! I've reviewed the user manual for the ADA Camera Mount models H583, H584 and H587, designed for cameras such as Huddly GO & Huddly IQ, Jabra PanaCast and Logitech BRIO. The document provides detailed instructions on mounting, with options for cable routing. I'm ready to answer any questions you might have about this product.
  • What is included in the box?
    What tools are needed for installation?
    Which cameras are compatible with ADA Camera Mounts?
H583 - ADA Camera Mount
for Huddly GO & Huddly IQ
2
IN THE BOX
ADA Camera Mount
1 x
Wall Achor
1 x
Hex Key, 5/32”
1 x
Mounting Screw
1 x
3
TOOLS NEEDED
COMPONENTS NEEDED
(Not Included)
1/2” Spade
Drill Bit
Tape Measure Power Drill
Pen
If you have any questions, please contact
service@hecklerdesign.com.
Phillips
head Bit
2m USB 3.0 Huddle Room/
Desktop Cable
Huddly GO & Huddly IQ
STEP 1
Locate mounting position
4
Important Notes:
Locate and mark the ideal location for your ADA Camera
Mount. It could be mounted underneath, above or beside
the display.
5
STEP 2
Install the wall anchor
6
Important:
Drill a 1/2-inch hole for the cable to
pass through the wall.
Optional
Mark and drill the hole
1 3/8”
1/2” hole
7
Optional
Route the USB-C cable through the wall
8
STEP 3
Fasten the ADA Camera Mount
Connect the USB-C cable to Huddly GO or
Huddly IQ Camera.
1.
Fasten the camera to the ADA Camera
Mount with the hex key.
2.
Install the Huddly GO or Huddly IQ
9
STEP 4
Loosen the screw with the hex hey to adjust
camera orientation, and then tighten it.
10
STEP 5
Adjust and set camera orientation.
H584 - ADA Camera Mount
for Jabra PanaCast
2
IN THE BOX
ADA Camera Mount
1 x
Wall Achor
1 x
Hex Key, 5/32”
1 x
Mounting Screw
1 x
3
TOOLS NEEDED
COMPONENTS NEEDED
(Not Included)
1/2” Spade
Drill Bit
Tape Measure Power Drill
Pen
If you have any questions, please contact
service@hecklerdesign.com.
Phillips
head Bit
Jabra PanaCast
USB Cable
Jabra PanaCast
STEP 1
Locate mounting position
4
Important Notes:
Locate and mark the ideal location for your ADA Camera
Mount. It could be mounted underneath, above or beside
the display.
5
STEP 2
Install the wall anchor
6
Important:
Drill a 1/2-inch hole for the cable to
pass through the wall.
Optional
Mark and drill the hole
1 3/8”
1/2” hole
7
Optional
Route the USB-C cable through the wall
8
STEP 3
Fasten the ADA Camera Mount
Connect the USB-C cable to Jabra
PanaCast Camera.
1.
Fasten the camera to the ADA Camera
Mount with the hex key.
2.
Install the Jabra PanaCast
9
STEP 4
Loosen the screw with the hex hey to adjust
camera orientation, and then tighten it.
10
STEP 5
Adjust and set camera orientation.
/