2. Vehicles & accessories
  3. Motor vehicle accessories & components
  4. Motorcycle Accessories
  5. Quoizel
  6. PCCME1718C
PCCME1718C

Quoizel PCCME1718C Installation guide

  • Hello! I've reviewed the installation guide for the light fixture PCCME1718C by QUOIZEL. This document provides detailed step-by-step instructions for assembly, wiring, and installation, along with important safety warnings and care guidelines. I'm ready to answer questions you might have about setting up your new light fixture.
  • What should I do before starting the installation?
    What tools are required for installation?
    How do I clean the fixture?
-of-13
CARE AND MAINTENANCE
SAFETY INFORMATION Released Date: 202 -3 02-23
INSTALLATION GUIDE FOR PCCME1718C
• Wipe clean using soft, dry cloth or static duster. Always avoid using harsh chemicals and abrasives to clean fixture as they may damage
the finish.
If you need further assistance call Quoizel Customer Care at 1-800-645-3184 (9:00am - 5:00pm EST), or visit us on-line at
www.quoizel.com.
AFixture Body
x 1
PACKAGE CONTENTS
MOUNTING HARDWARE
Crossbar
x1
AA Wire Connector
x5
CC Outlet Box Screw
x2
DD
Mounting Screw
x2
BB
BRod A
x2 CRod B
x2
A
B
AB
ECrystal Bar
x2
Ratings
120Vac, 60Hz
Model No. Wattage
PCCME1718C 28W
Please read and understand this entire manual before attempting to assemble, install or
operate the product.
WARNING
• RISK OF ELECTRIC SHOCK - Before beginning installation, turn off electricity at the
circuit breaker box or the main fuse box.
CAUTION
• For your safety, read instructions completely before beginning installation.
• If in doubt about electrical installation, consult a licensed electrician.
TOOLS REQUIRED
DSpanner
x1
-of-23
INSTALLATION
1
Install Crystal Bar, Rod A to Ceiling Canopy
2
Install Crystal Bar, Rod B to Ceiling Canopy
AA
A
A
1. Line Rods A to Location A on the ceiling canopy during
assembly.
2. Remove Labels “A” from ceiling canopy and Rods after
assembly.
BB
B
B
4
Install Crossbar
5
Install Lanyard
3
Connect Fixture Wires to Driver
Red fixturewire from
identified with the label “LED +”
Red Driverwire from
identified with the label “LED +”
Yellow wire from fixture
identified with the label “LED ”-
Yellow Driverwire from
identified with the label “LED ”-
6
Connect Supply Wires to Driver
White wire from supply White wire from Driver
Black (or red) wire from supply Black wire from Driver
Ground wire from supply
Ground wire
from fixture
Green ground screw
Lanyard
Button Stop
Lanyard
1. Line Rods to Location on the ceiling canopy duringBB
assembly.
2. Remove Labels “B” from ceiling canopy and Rods after
assembly.
-of-33
INSTALLATION
7
Install Fixture Body to Crossbar
Your installation is now complete! Restore electricity and save this sheet for future reference.
/