2. CUMBERLAND CONNECT
  3. GM1020
GM1020

CUMBERLAND CONNECT GM1020 User guide

  • Hello! I've reviewed the Quick Start Guide for GigaMesh and GigaSpire. It covers how to connect, pair, and find the ideal location for your GigaMesh using its LED indicators. I'm ready to help answer any questions you have about the setup process.
  • How long should I press the WPS button on GigaMesh and GigaSpire?
    What color should the LED be when pairing is successful?
    What happens if the LED flashes red?
Need help?
Contact Technical Support: 1-800-987-2362 or [email protected]
Quick Start Guide:
Setting up your GigaMesh
When the LED is ashing
red, you can pair the
GigaMesh with the
GigaSpire. Press and
hold the WPS buttons
on the GigaMesh and then on the
GigaSpire for 3 seconds each (less
than 30 seconds apart). The LEDs
ash green while attempting to pair.
Connect GigaMesh
to power outlet.
Use the solid green LED indicator (displays for 60 seconds
at end of pairing cycle) to determine ideal location for the
GigaMesh. If necessary, relocate it to a more ideal distance
from the GigaSpire and conrm successful pairing after the
GigaMesh reboots (repeating steps 2-3 as needed).
GigaMesh location is
ideal distance from
GigaSpire.
Move GigaMesh closer
to GigaSpire.
Move GigaMesh farther
away from GigaSpire.
If applicable, use the CCFiber
SmartIQ app to set up the
GigaSpire. See the CCFiber
SmartIQ Quick Start Guide for
guidance.
60s 2m
1s
5s
4m
3s
Note: Once successful pairing is complete, the
GigaSpire and GigaMesh LEDs will both show a
solid cyan (light blue) color. It may take several
minutes to reach this state.
60s 2m
1s
5s
4m
3s
/