2. Gainsborough
  3. Classic Series Dummy Knob

Gainsborough Classic Series Dummy Knob Installation guide

  • Hello! I have reviewed the provided installation instructions for the Classic Range Dummy Knob. This document details the process of installing the dummy knob, including preparing the door with accurate hole placement using the included template. I can answer questions about steps, tool usage and provide key installation torque values specific to this product. How can I help you today?
  • What is the recommended torque for tightening screws?
    What size holes should be drilled according to the template?
ORIGINATION CRM GSH 853 0612
Fit here on door edge
Fit here on door edge
BACKSET 60mm
BACKSET 70mm
FOLD HERE
Installation template
for dummy applications
Installation Instructions for Classic Range Dummy Knob
NOTE: Carefully follow these instructions when installing.
Screws to be tightened to a recommended 2.5Nm torque.
Step 1.
Step 2.
Install knob assembly to door
• Fit posts (7) to dummy plate (4) with screws (6).
• Place dummy plate (4) into position, on back of door.
• Fit fixing disc (3) to front of door & secure in place with screws (2).
• Place dummy knob assembly (1) onto fixing disc (3) and secure
by turning the rosette in a clockwise direction until tight.
12mm hole
8mm hole
8mm hole
Allegion Australia
Melbourne, Australia. A.B.N. 
www.gainsboroughhardware.com.au
AT 000
CLADOC01YL1
JUN ‘12
• Fold Template where indicated.
• Position template on door edge at desired height.
• Firmly hold template & mark 3 hole centres (2 off 8mm
& 1 off 12mm) at required backset.
• Drill Pilot holes - suggest 3mm, then enlarge to required size
from both sides of door.
1
2
4
6
7
3
/