Page is loading ...
User’s Manual
ZM-NSP100
www.ZALMAN.com
Ver. 1.1
1
.COM
1. Precautions
2. Specifications
1) Check the components list and condition of the product before
installation. If any problem is found, contact the retailer to obtain a
replacement.
2) Excessive force exerted on the fan may cause damage to the fan and/
or system.
3) Please check if all cords are connected properly prior to use.
4) Please keep units away from water and liquids to prevent damages.
5) Please keep out of way of humidity, direct sunlight, heat appliances and
other heat emitting devices.
6) Please check that USB device is properly recognized by your Operating
System.
7) Please install unit in a vibration-free and stable environment.
8) Product design and specifications may be revised to improve quality
and performance.
Model
Spec.
ZM-NSP100
Power 3W + 3W = 6W RMS Total
Speakers 30mm 4Ohm 3W x 2pcs
Frequency Response Range 60Hz~18KHz
Dimensions (W x D x H) 50 x 40 x 120mm
Weight 150g
Connectivity
Cable length 0.75m
Connectors USB Port
USB USB 2.0
Convenience
Plug and Play Yes
Travel Pouch Included Yes
System
Requirement
USB Free USB Port
OS
Win98 SE, ME
2000, XP, Vista, Win7
Mac OS X or higher
Loud Speaker Magnet System Neodymium
O
peration Temperature 0 to 45 degrees ℃
Operation Humidity 20% to 90% H
Disclaimer) Zalman Tech Co., Ltd. is not responsible for any damages due to
external causes, including but not limited to, improper use, problems
with electrical power, accident, neglect, alteration, repair, improper
installation, or improper testing.
2
.COM
4. Installation
1) Clip or place portable speakers to each side of Notebook
Computer.
2) Connect the portable speakers to the Notebook Computer’s USB
Port with the USB Connector.
OR
3. Components
Travel PouchSpeakers
3
.COM
After use, store speakers in the Travel Pouch.
[Note] If you cannot find the USB speaker device on your PC,
[PC]
Click ‘Control Panel’.
Double-click ‘Sound and Audio
Devices’.
In ‘Sound and Audio Devices’
properties, go to audio playback
and record setting to check if
‘USB audio device’ has been
selected.
- System Requirements:
Windows XP or higher with
certified USB controller
[MAC]
Click ‘System User Environment’.
Click ‘Sound’ icon.
Open the ‘Output’ property and
select ‘USB Sound Device’.
Play music using the multimedia
software.
- System Requirements:
MAC OS 9 or higher with built-in
USB connector
5. Speaker Storage
3) Turn on the audio and adjust the volume using the PC’s software.
/