luminii DDW-MC Installation guide

Type
Installation guide
REV0.1 10172018*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
Please read all instructions prior to installation and keep for future reference!
1. Product to be installed by a qualied electrician.
Dynamic white Controller - Installation Instructions
Models DDW-MC
Pag 1 of 1
7777 N. Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
www.luminii.com
2
2.1 Align the back of the controller face to the controller housing
and snap in to secure.
1
junction
box
1.1 Align the controller housing to the junction box and secure using
the two screws. Remove plastic film from the battery slot.
controller
housing screw
1.1
battery slot
2.1
controller face
+
-
+
-
PRIMARY
24VDC
INPUT
SECONDARY WW
R
+
-
CW
G
+
-
WW
B
+
-
CW
W
+
-
+
-
-
Input
120V AC
RGBW-RC-R receiver
power supply
24VDC
OUTPUT
+
-
120VAC
INPUT
L
N
Controller
Operations to controller
1. Press the learning key on the receiver, then push the rotary button on the controller. Once successfully learn, the LED lights will blink on the receiver. Do
the same for the other receivers if you use them, you can add as many optional receivers as you want.
Short press once the rotary button to switch on/off.2.
Adjust dim brightness by the rotary button from left to right 0.1 - 100%.
Adjust dim brightness by the rotary button from right to left 0.1 - 100%.
Double click rotary button, it will enter into dimming color temperature mode, dim WW & CW associatively, for example if WW is 70%, CW is 30%.
Double click again, will enter into dimming brightness mode.
If necessary controller battery can be replaced by pulling off the controller face plate, then replacing battery from the battery slot.
WW
CW
signal
LEARNING
KEY
ROTARY
BUTTON
rotary button
controller
housing
dynamic white LineLED
  • Page 1 1

luminii DDW-MC Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI