2. Rock Slide Engineering
  3. Bronco Magnet Mount

Rock Slide Engineering Bronco Magnet Mount Installation guide

  • I've reviewed the instructions for the Bronco Magnet Mount. This document provides step-by-step guidance on installing the mount, including the use of VHB tape and the importance of proper magnet alignment. I'm ready to answer any questions you may have regarding the installation process.
  • What kind of tape is used to secure the mount?
    What should I do before permanently securing the mount?
    What is the purpose of the alcohol pad?
ROCKSLIDEENGINEERING.COM - NEED ASSISTANCE? 435.752.4580 - PAGE 1 REVISED 4/4/2022
IMPORTANT
BRONCO MAGNET MOUNT
INSTALLATION
Made in the USA
MAGNET MOUNT ASSEMBLY
1. Remove the yellow backing from the thin black VHB tape and adhere it to the front cutout of the magnet mount.
2. Clean your magnet with the alcohol pad before securing to the VHB.
3. Flip the mount to the back and use two strips of the thick VHB tape to secure your mount to the Bronco. Leave the backing in place
until test fit is complete.
IMPORTANT
Do a test fit to make sure the magnet is properly aligned with the door sensor BEFORE securing the mount onto the Bronco with the VHB.
MAGNET LOCATION
The Bronco Magnet Mount has been added for ease of installation. If your magnets are already installed, mark their location for
replacement. For new installs, use the magnet location on the installation instruction for location reference.
/