2. TRIUMPH BOARD
  3. Speakers

TRIUMPH BOARD Speakers Installation guide

  • Hello! I'm your chat assistant, and I've reviewed the installation guide for the TRIUMPH BOARD MULTI Touch Speakers. This document provides step-by-step instructions for mounting the speakers and connecting them to your interactive whiteboard, and includes specific notes for certain models (8592580120015 and 8592580120008). I'm here to assist with any questions you have about the installation process.
  • What wall mount should be used for installing MULTI Touch boards with MULTI Touch Speakers?
    Where should the speaker's HUB be attached?
    How are speakers attached to the board?
    What type of screws should be used for IWBs EAN 8592580120015 and 8592580120008?
    How are the IWBs EAN 8592580120015 and 8592580120008 connected?
MULTI Touch Speakers Installation Guide
Note: For wall installation of MULTI Touch boards with MULTI Touch Speakers use 40 mm
Wall Mount supplied with MULTI Touch Speakers
1. Attach suspender (6) by screwing to board, see figure 1
2. Measure the position of top hangers for hanging (3), see figure 1
3. Install wall plugs (1) and hangers 40mm (3), see figure 1
Figure 1
4. Use double side tape to attach the speaker´s HUB in center of the pentray,
5. Attach speakers to the frame from back of the board, see figure 2
Figure 2
Note:
For IWBs EAN 8592580120015, 8592580120008,
please use M6 screws.
6. Lead / hide cables behind the board using tape
7. Install pentray with HUB on the board
8. Connect HDMI – HDMI and L and R Audio cables, see figure 3
Note: For IWBs EAN 8592580120015, 8592580120008, please use the USB output
with USB – USB B cable attached in the IWB box.
Figure 3
9. Measure and install wall plugs (1), screws (2) and square (4), see figure 1
10. Hang board on the wall
11. Connect board to the PC with micro USB - USB cable, see figure 3
/