3
IMPORTANT SAFEGUARDS
For your own safety read the following instructions carefully before attempting to connect this unit to
mains power:
You should only plug the appliance into a 220V-240V AC, 50Hz supply. Connecting it to other power
sources will damage the appliance.
1. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
2. Children should be supervised to ensure that they do not play with the appliance.
3. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
4. The kettle is only to be used with the stand provided.
5. CAUTION: Do not operate the kettle on an inclined plane, Do not operate the kettle unless the
element is fully immersed. Do not move while the kettle is switched on.
6. This appliance is intended to be used in household and similar applications such as:
– staff kitchen areas in shops, offices and other working environments;
– farm houses;
– by clients in hotels, motels and other residential type environments;
– bed and breakfast type environments.
7. For additional protection, we recommend the use of a power outlet with a rated current of 10A. To
avoid circuit overload, do not operate another high wattage appliance on the same circuit
8. Do not fill the kettle when positioned on the base and always dry the bottom before placing it on the
power base
9. Never leave the device unattended when in use
10. Do not use the kettle to heat anything other than water.
11. Do not fill above the “Max” indication
12. Do not operate the kettle if it is below the “Min” indication
13.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your local authority for recycling advice.
SAVE THESE INSTRUCTIONS FOR HOUSEHOLD USE ONLY
Any servicing should be performed by an authorized service representative.
ELECTRIC REQUIREMENTS
Voltage: 220-240V.A.C Hertz: 50Hz Power: 1850-2200W