Extron TLP 710MV Template

Cut-Out Template for the Extron

TLP 710MV

1. Confirm the product to be installed.

2. Remove the surface cut-out (gray) area

from the template.

3. Mark the position on the wall or

furniture where the TLP 710MV

is being installed.

4. Cut the opening.

P/N 68-2162-01 Rev. A

Outer Edge of Front Bezel

(Do not cut this line.)

Mounting Holes (4)

SURFACE

CUT-OUT

AREA

5.813"

(14.76 cm)

7.5"

(19.05 cm)

Print this

template

at 100% on

11" x 17" paper

7.914"

(20.10 cm)

0.207"

(0.53 cm)

4.094"

(10.40 cm)

0.860"

(2.18 cm)