CRX Installing and connecting the refrigerator
23
A
➤ Before starting up the device for the first time, check whether the operating volt-
age and the battery voltage match (see type plate).
➤ Connect your refrigerator to a plug socket which is fuse-protected at 15 A (at
12 V) or 7.5 A (at 24 V) (fig. e 1, page 9).
➤ Connect the red cable (fig. e rd, page 9) to the positive terminal of the battery.
➤ Connect the black cable (fig. e bk, page 9) to the negative terminal of the
battery.
7.7 Connecting the refrigerator to AC voltage
D
CRX50ACDC, CRX65ACDC, CRX80ACDC, CRX110ACDC, CRX140ACDC
Proceed as follows when you connect the refrigerator to the AC supply:
➤ Plug the connector into the AC socket (fig. f 1, page 10).
CRX50DC, CRX65DC, CRX80DC, CRX110DC
You can connect the refrigerator to 100 – 240 Vw AC power if you use the MPS35
rectifier (accessory).
The MPS35 rectifier features a priority circuit which conserves the battery con-
nected. When a 100 – 240 Vw mains connection is used, the rectifier automatically
switches from battery to mains operation.
When disconnected from the 100 – 240 Vw mains supply, the rectifier automatically
switches back to battery operation. Mains operation via the rectifier always takes pri-
ority over battery operation.
NOTICE! DANGER OF DAMAGE
Make sure the polarity is correct.
DANGER! DANGER OF ELECTROCUTION
• Never handle plugs and switches with wet hands or if you are stand-
ing on a wet surface.
• If you are operating your refrigerator on board a boat with an
AC mains connection using a shore connection, you must install a
residual current circuit breaker between the AC mains supply and
the refrigerator.
Seek advice from a trained technician.
CRX50-65-80-110-140-IO-US.book Seite 23 Montag, 22. Oktober 2018 11:01 11