Refrigerator
Installation and Operating Manual
EN
CoolMatic
RPD190V120,
RPD218V120
RPD190V120, RPD218V120
3
RPD190V120
1
2
3
4
6
5
1
RPD190V120, RPD218V120
4
1
2
3
4
6
5
RPD218V120
2
MODE
1 2 3 4
5
6
3
RPD190V120, RPD218V120
5
1
3
2
4
RPD190V120, RPD218V120
6
min. 580 mm
(min. 22.8")
610 – 620 mm
(24" – 24.4")
RPD190: 1422 – 1432 mm (56" – 56.4")
RPD218: 1580 – 1590 mm (62.2" – 62.6")
5
>∅25.4 mm
(>∅1")
21
6
RPD190V120, RPD218V120
7
7
8
RPD190V120, RPD218V120
8
1.
2.
3.
9
0
RPD190V120, RPD218V120
9
1
a
21
b
RPD190V120, RPD218V120
10
1. 2.
4.3. 5.
c
RPD190V120, RPD218V120
11
600 (23.6")
1389 (54.7")
580 (22.8")
611 (24.0")
633 (24.9")
230
(9")
40
(1.6")
1360 (53.5")
RPD190V120
d
RPD190V120, RPD218V120
12
580 (22.8")
RPD218V120
1545 (60.8")
1516 (60.0")
600 (23.6")
611 (24.0")
230
(9")
40
(1.6")
633 (24.9")
e
EN
RPD190V120, RPD218V120
13
Please read this instruction manual carefully before installation and
first use, and store it in a safe place. If you pass on the product to
another person, hand over this instruction manual along with it.
Table of contents
1 Explanation of symbols . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
2 Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
3 Scope of delivery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
4 Intended use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
5 Technical description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
6 Installing and connecting the refrigerator. . . . . . . . . . . . . . . . . . . . . 20
7 Using the refrigerator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
8 Cleaning and maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
9 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32
10 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34
11 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34
12 Technical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35
EN
Explanation of symbols RPD190V120, RPD218V120
14
1 Explanation of symbols
D
!
!
A
I
➤ Action: This symbol indicates that action is required on your part. The
required action is described step-by-step.
✓ This symbol describes the result of an action.
Fig. 1 5, page 3: This refers to an element in an illustration. In this case,
item 5 in figure 1 on page 3.
DANGER!
Safety instruction: Failure to observe this instruction will cause
fatal or serious injury.
WARNING!
Safety instruction: Failure to observe this instruction can cause
fatal or serious injury.
CAUTION!
Safety instruction: Failure to observe this instruction can lead to
injury.
NOTICE!
Failure to observe this instruction can cause material damage and
impair the function of the product.
NOTE
Supplementary information for operating the product.
EN
RPD190V120, RPD218V120 Safety instructions
15
2 Safety instructions
The manufacturer accepts no liability for damage in the following cases:
Faulty assembly or connection
Damage to the product resulting from mechanical influences and excess
voltage
Alterations to the product without express permission from the manu-
facturer
Use for purposes other than those described in the operating manual
2.1 General safety
D
DANGER!
On boats: If the device is powered by the mains, ensure that the
power supply has a residual current circuit breaker. The break
distance must not be less than 3 mm.
!
WARNING!
Have a qualified technician perform the installation in wet
rooms.
Do not operate the device if it is visibly damaged.
If this device's power cable is damaged, it must be replaced by
the manufacturer, customer service or a similarly qualified
person in order to prevent safety hazards.
This device may only be repaired by qualified personnel.
Inadequate repairs may cause serious hazards.
This device can be used by children aged 8 years or over, as
well as by persons with diminished physical, sensory or mental
capacities or a lack of experience and knowledge, providing
they are supervised, or have been taught how to use the device
safely and are aware of the resulting risks.
Cleaning and user maintenance must not be carried out by
children without supervision.
Children must be supervised to ensure that they do not play with
the device.
Always keep and use the device out of the reach of children
under 8 years of age.
Do not store any explosive substances, such as spray cans with
propellants, in the device.
EN
Safety instructions RPD190V120, RPD218V120
16
!
CAUTION!
Danger of crushing! Do not put your fingers into the hinge.
Foodstuff may only be stored in its original packaging or in suit-
able containers.
A
NOTICE!
Check that the voltage specification on the type plate is the
same as that of the power supply.
Never pull the plug out of the socket by the connection cable.
The refrigerator is not suitable for transporting substances
which are caustic or contain solvents.
Keep the drainage outlet clean at all times.
Do not open the refrigerant circuit under any circumstances.
Never transport the device in a horizontal position, so that no oil
can leak out of the compressor.
Make sure that the refrigerator circuit is not damaged during
transportation. The refrigerant in the refrigerator circuit is highly
flammable.
In the event of any damage to the refrigerator circuit:
– Avoid naked flames and sparks.
– Air the room well.
Set up the device in a dry location where it is protected against
splashing water.
EN
RPD190V120, RPD218V120 Safety instructions
17
2.2 Operating the device safely
D
DANGER!
Do not touch exposed cables with your bare hands.
!
CAUTION!
Before starting the device, ensure that the power supply line
and the plug are dry.
If you connect the device to a battery, make sure that no food
comes into contact with the battery acid.
Do not use extension cords.
A
NOTICE!
Do not use electrical devices inside the cooling device unless
they are recommended by the manufacturer for that purpose.
Do not place it near naked flames or other heat sources
(heaters, direct sunlight, gas ovens etc.)
Danger of overheating!
Always ensure sufficient ventilation so that the heat generated
during operation can dissipate. Make sure that the device is
sufficiently far away from walls and other objects so that the air
can circulate.
Ensure that the ventilation vents are not covered.
Do not fill the inner container with ice or fluid.
Never immerse the appliance in water.
Protect the appliance and the cable against heat and moisture.
Make sure that foodstuffs do not touch the walls of the cooling
area.
EN
Scope of delivery RPD190V120, RPD218V120
18
3 Scope of delivery
4 Intended use
The RPD series refrigerators are suitable for refrigerating foodstuffs
and storing frozen foodstuffs.
The device is also suitable for use on boats.
The device is designed to be operated from a 120 V supply.
!
The refrigerator is only suitable for installation in a fitted cavity. Once it is
installed, only the front of the appliance may be accessible.
Quantity Description
1 Refrigerator
1 Lower ventilation grille
1 Drain hose
2 Icecube tray
1 LH hinge conversion kit (with instruction)
2 Airing position card
1 Operating manual
CAUTION! Health hazard!
Please check if the cooling capacity of the device is suitable for
storing the food or medicine you wish to cool.
EN
RPD190V120, RPD218V120 Technical description
19
5 Technical description
5.1 Function description
The device can refrigerate goods to +7 °C to +2 °C (45 °F to 36 °F) and keep
them cool. Products can be frozen to –10 °C to –18 °C (14 °F to 97 °F) in the
freezer compartment. You can use the variable thermostat to set the desired
temperature.
The refrigerator is suitable for use with a 120 V supply.
When used on boats the refrigerator can be subjected to a constant
inclination of 30°.
All materials used in the refrigerator are compatible for use with foodstuffs.
The refrigerant circuit is hermetically sealed and CFC-free.
5.2 Control elements inside the refrigerator
The various types of refrigerators are shown in the following illustrations:
RPD190V120: fig. 1, page 3
RPD218V120: fig. 2, page 4
No. Description
1 Freezer compartment
2 Control panel
3 Wire shelf (folding, so that bottles can be put in the refrigerator)
4 Shelf
5 Crisper bin
6 Door shelf
EN
Installing and connecting the refrigerator RPD190V120, RPD218V120
20
5.3 Control elements
6 Installing and connecting the
refrigerator
Please note the following instructions for installation on boats:
D
A
6.1 Reversing the doors
With the LH hinge conversion kit you can change the hinge of the door, so
that it opens to the left instead to the right. A separate instruction sheet is
included with this kit.
No. in
fig. 3, page 4
Description
1 ON/OFF button
2 Power LED
3 Status LED
4 Mode button
5 Temperature level LEDs
6 Temperature setting button
DANGER!
If the device is powered by the mains, ensure that the power
supply has a residual current circuit breaker.
NOTICE!
The device can be tilted sideways up to 30°. When setting up
the refrigerator, note that it must be fastened to take account
of this. If you have any questions regarding installation, consult
your specialist dealer.
Install the refrigerator so that the warm air generated can
easily flow away (fig. 4, page 5)
The appliance is designed for ambient temperatures between
+16°C and +43°C (61°F to 109°F).
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/
