Balham Dummy 2 Drawer
BOSCH Dishwasher Application
HD811121
Follow the diagram below for the fixing locations of your Balham dummy 2 drawer profile frontal.
This application will require applying additional spacing to the back of the frontal using worktop trim (WKP5295). It will also
require drilling through the back of the dishwasher door in two locations .
1. Position dishwasher and level.
2. Hold door against dishwasher, aligning with other frontals
and mark the top (back) of the door as shown.
3. Cut/secure edging strip to the back of the door (top & bottom),
aligning with the pencil mark.
Note: Bottom strip will require double thickness.
4. Fit the door to the dishwasher following the manufacturers guidelines.
5. Drill through dishwasher casing for the additional screw locations.
6. Secure frontal using the 6 long screws provided.
Edging
strip x2*
100mm
Align door
Fit the short casing
screw (removed from
location 3) here
x2 x2
x1x1
Edging
strip x1*
*dark edge facing top
Back of dishwasher
dummy 2 drawer
frontal
Back of dishwasher
dummy 2 drawer
frontal
2
11
2
3 3
Fit the short casing
screw (removed from
location 3) here
/