Page is loading ...
READANDUNDERSTANDTHESEINSTRUCTIONSBEFOREINSTALLINGFIXTURE
lNSTRUCllON SHEET NO.
‘hisfixlureisintendedforinstallationinaomdancewilh the National Electrical Code and
local regulation.
o assure
fullmmpliancewithIosd codesandregulations,deck withyourlocalelecfricelinapecforbefore
Iatallation,To preventelectricalshock,tumoff electricityatfuseboxbeforeproceeding,
IS:2002
Retaintheeeinstructionsformaintenancereference.
ROS92
INSTALLATION PROCEDIJRE FOR FRAME-IN KIT (NEW CONSTRUCTION ONLY)
‘GA g 5’” ~ ,
FIG. B FIG. C FIG. D
1,
FRAME-IN
2. CLOSE-IN
3. SNAP-ON
4, PUSH-UP
WARNING–(RISK OF FIRE) DO NOT INSTALL INSULATION WITHIN 3 INCHES OF FIXTURE SIDES OR
WIRING COMPARTMENT, NOR ABOVE FIXTURE IN SUCH A MANNER TO ENTRAP HEAT.
1.
2.
NOTE: For wet plaster ceiling, use
Plaster Ring Accessory No. 1959
,, ~ ROTO-CLIP
(order separately),
1
3. SNAP-IN (Fig. C). ~F:/~’$’flT~lM
&
INSTRUCTION
‘w
4. PUSH-UP (F@. 0). SHEETS,
U.S. PA TENT NO. 4,039,822.
FIG. G
OTHER u.S. AND FOREIGN PA TENTS PENDING.
WARNING:USE ONLY REFLECTORTRIMS PROVIDED BY LIGHTOLIERINC. USE OF OTHER
MANUFACTURERS’REFLECTORTRIMS VOIDS THE UNDERWRITERSLABORATORIESLISTING
AND COULD CONSTITUTEA FIRE HAZARD.
1.1<5
I“ITC>I.IE R“ Ri:%%iwun;
—
/
