Lightolier IS:2002 User manual

READANDUNDERSTANDTHESEINSTRUCTIONSBEFOREINSTALLINGFIXTURE

lNSTRUCllON SHEET NO.

‘hisfixlureisintendedforinstallationinaomdancewilh the National Electrical Code and

local regulation.

o assure

fullmmpliancewithIosd codesandregulations,deck withyourlocalelecfricelinapecforbefore

Iatallation,To preventelectricalshock,tumoff electricityatfuseboxbeforeproceeding,

IS:2002

Retaintheeeinstructionsformaintenancereference.

ROS92

INSTALLATION PROCEDIJRE FOR FRAME-IN KIT (NEW CONSTRUCTION ONLY)

‘GA g 5’” ~ ,

FIG. B FIG. C FIG. D

FRAME-IN

2. CLOSE-IN

3. SNAP-ON

4, PUSH-UP

WARNING–(RISK OF FIRE) DO NOT INSTALL INSULATION WITHIN 3 INCHES OF FIXTURE SIDES OR

WIRING COMPARTMENT, NOR ABOVE FIXTURE IN SUCH A MANNER TO ENTRAP HEAT.

NOTE: For wet plaster ceiling, use

Plaster Ring Accessory No. 1959

,, ~ ROTO-CLIP

(order separately),

3. SNAP-IN (Fig. C). ~F:/~’$’flT~lM

INSTRUCTION

‘w

4. PUSH-UP (F@. 0). SHEETS,

U.S. PA TENT NO. 4,039,822.

FIG. G

OTHER u.S. AND FOREIGN PA TENTS PENDING.

WARNING:USE ONLY REFLECTORTRIMS PROVIDED BY LIGHTOLIERINC. USE OF OTHER

MANUFACTURERS’REFLECTORTRIMS VOIDS THE UNDERWRITERSLABORATORIESLISTING

AND COULD CONSTITUTEA FIRE HAZARD.

1.1<5

I“ITC>I.IE R“ Ri:%%iwun;

—