2. ID TECH
  3. SecuRED

ID TECH SecuRED User manual

  • Hello! I have reviewed the user manual for the ID TECH SecuRED BootLoader and understand it describes the procedures for updating firmware using USB HID and RS232 interfaces. It specifies a 2-3 minute firmware update duration. I'm ready to answer your questions about the device and its usage.
  • How do I start the boot load process using USB HID?
    What is the next step after clicking "BootLoad" button in USB HID?
    How long does the firmware update take?
    How do I start the boot load process using RS232?
1
User Manual for SecuRED BootLoader
1. USB HID Device
Step1: Plug in SecuRED to PC then open “BootLoader_USBHID”
software. Click “BootLoad” button to start boot load progress.
USB Boot Loader software
Step2: Choose one firmware file, and then click “Open Button”
2
Step3: While firmware update complete, there is a prompt “bootload
finish” popped up.
3
Note: Firmware update progress will perform about 2~3 minutes, please do not power
down device before firmware update complete.
2. RS232 Device
Step1: Plug in DC 5V power supply with secured and then connect
device to PC. Open BootLoader_RS232 software. Choose serial port.
Then click” BootLoad” button.
Step2: Choose one firmware file, and then click “Open Button”
4
Step3: While firmware update complete, there is a prompt “bootload
finish” popped up.
Note: Firmware update progress will perform about 2~3 minutes, please do not power
down device before firmware update complete.
/