2. Computers & electronics
  3. Telecom & navigation
  4. Mobile phones
  5. Car kits
  6. Havis-Shields
  7. Telescoping Computer Base C-TCB-7-IMP

Havis-Shields Telescoping Computer Base C-TCB-7-IMP, C-TCB-7-IMP User manual

  • Hello! I am an AI chatbot trained to assist you with the Havis-Shields Telescoping Computer Base C-TCB-7-IMP User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
C-TCB-7-IMP-INST-12-04
INSTALL INSTRUCTIONS C-TCB-7-IMP
TELESCOPING COMPUTER BASE
CHEVROLET IMPALA SPECIFIC
C-SERIES-IMP CONSOLIDATOR® CONSOLE MOUNT
(Example: C-1400-IMP)
TOOLS REQUIRED:
3/16” Allen wrench Open-end wrench set
HARDWARE & COMPONENETS:
QTY DESCRIPTION PART #
1 Pole support assembly CM93071-7
1 Telescoping pole assembly CM93072-1
1 Spacer bracket CM93381
4 ¼-20 Hex nut GSM30005
4 ¼”Flat washer GSM31005
2 ¼-20-x ½”Hex head bolt GSM33000
2 ¼-20 x 1”Hex head bolt GSM33002
Always!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
Pole support
assembly
Telescoping pole
assembly
¼-20 x ½” Hex
head bolt & ¼” Flat
washer
Spacer Bracket w/
¼-20 x ¾” Hex
head bolt & ¼” Flat
washer
C-TCB-7-IMP-INST-12-04
SUB ASSEMBLY:
1. Confirm receipt of all hardware and components.
2. Install Chevrolet Impala Specific C-Series-IMP Consolidator® into vehicle using hardware
and instructions provided.
3. Determine location on console to mount C-TCB-7-IMP and be sure to leave room on
passenger side of console to mount.
INSTALLATION:
1. Mount C-TCB-7-IMP on side of Chevrolet Impala Specific C-Series-IMP console.
• Position C-TCB-7-IMP on Passenger side of console.
• Attach to lower rail of console first.
• Position spacer bracket between C-TCB-7-IMP and C-Series-IMP console.
• Align nuts in rails to slotted holes on pole support assembly.
• Attach pole support assembly and spacer bracket to console using ¼-20 x ¾” Hex
head bolts, washers and nuts with in the console rail.
• Now attach top of C-TCB-7-IMP using only ¼-20 x ½” Hex head bolts, washers and
nuts with in console rail.
Note: Rails of console have (4) ¼-20 hex nuts on both top and bottom. (Extra nuts are
provided if needed)
• Attach optional C-3090 Computer mounting platform to Telescoping pole assembly.
C-TCB-7-IMP mounted
on a C-1400-IMP console
(sold separately)
/