SURROUND
Installation Instructions
clarus.com | 888.813.7414 © 2017 Clarus. All rights reserved.
TOOLS NEEDED
PROVIDED HARDWARE
PREPARE YOUR
GLASSBOARD FLOAT
INSTALLATION
• Drill
• 1/4” Drill Bit
• Phillips Head Screw Driver
• Level
• Tape Measure
• Pencil
• Safety Gloves
• Safety Goggles
• Size 8 Screws
• Drywall Anchors
• Wall Bracket
• Wall Shims
1. Follow uncrating instructions found on the exterior
of your crate
1. Locate provided hardware
1. Measure the distance from the top of the board, to the
boom of each row of TruMount Clips (clip adhered to
the Glassboard). Add 7/8” to that measurement, this is
where you’ll line up the boom of the wall bracket.
2. Level wall brackets and mark hole locations with pencil.
3. Drill pilot holes for drywall anchors.
4. Install provided drywall anchors into pilot holes
5. Install wall bracket into drywall anchors with provided
screws, placing shims behind wall bracket over each
pilot hole Fig. A
6. Ensure screws are flush to wall bracket to prevent
scratching your glassboard
7. Hang glassboard ensuring the TruMount clip is secure to
the wall bracket Fig. B
Fig. A
Fig. B
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Ghent PRW1M23BCWH Operating instructions
-
Ghent Coda Circle Glassboard Installation guide
-
JasonL EWS36-36GB-BE Operating instructions
-
Ghent PNT1PN7736BLKCAS Assembly Instructions
-
Lintex 28828 Datasheet
-
Lintex 40290 Datasheet
-
Amico Bariatric Power Traverse Straight Track Ceiling Lift Systems User manual
-
SelectBlinds Cordless Roller Shade Installation guide
-
GE CV936 User manual
-
