Lumination LUXE series Installation guide

Lumination
Brand
Lumination
Model
LUXE series
Type
Installation guide
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 1 of 9
(Rev 05/16/23)
RCMANU5955A LUXE SERISE INSTSHT
• Do not use outdoors.
• Do not mount near gas or electric heaters.
• Equipment should be mounted in locations and at heights (MAX: 8ft) where it will not readily be subject to tampering by unauthorized
personnel.
• The use of accessory equipment not authorized by the manufacturer may cause an unsafe condition.
• Do not use this equipment for other than its inteded purpose.
• Before wiring to power supply, turn o electricity at fuse or circuit breaker.
• Consult local building code for approved wiring and installation.
• Installation and servicing of this equipment should be performed by qualied service personnel.
INSTALLER:
• See unit label for additional model specications
WARNING:
• This product contains chemicals known to the State of California to cause cancer, birth defects and/or other reproductive harm. Thoroughly
wash hands after installing, handling, cleaning, or otherwise touching this product.
Installation Guide
LED Emergency Exit
(LUXE Series)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
When using electrical equipment, basic safety precautions should always be followed including the following.
WARNING/AVERTISSEMENT
Save These Instructions
Use only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 1 of 9
(Rev 05/16/23)
RCMANU5955A LUXE SERISE INSTSHT
Lumination® (LUXE Series) Installation Guide
Ceiling & End Mounting
Connect input as shown in wiring diagram below and
fasten canopy to J-box bracket.
1
Snap housing to canopy.
If the exit has remote capacity, up to 4 remotes can be
connected.
Secure faceplate to housing and remove the proper arrow
as required.
2
3
4
NOTICE:
MUST WEAR GLOVE FOR ALL INSTALLATION PROCESSES
WARNING: UNUSED WIRES MUST BE CAPPED USING
ENCLOSED WIRE NUTS.
Wiring Diagram
EXIT SIGN EXIT SIGN WITH REMOTE CAPACITY
BLACK 120VAC
LED BOARD
RED 277VAC
T R S
WHITE COM
BAT. 2. 4V
40 0MAH
RECYCLING INFORMATION
All steel, aluminum, and thermoplastics
parts are recyclable.
All cartons contain recycled materials.
Please recycle responsibly.
Specications subject to change without notice.
  • Page 1 1
  • Page 2 2

Lumination LUXE series Installation guide

Lumination
Brand
Lumination
Model
LUXE series
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents