Lumination Luce Installation guide

Lumination
Brand
Lumination
Model
Luce
Type
Installation guide
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 1 of 9
(Rev 05/16/23)
RCMANU5957A LUCE _instsht
WARNING/AVERTISSEMENT
• Do not let power supply cords touch hot surfaces.
• Do not use outdoors.
• Do not mount near gas or electric heaters.
• Equipment should be mounted in locations and at heights (MAX: 12ft) where it will not readily be subject to tampering by unauthorized
personnel.
• The use of accessory equipment not authorized by the manufacturer may cause an unsafe condition.
• Do not use this equipment for other than its inteded purpose.
• Servicing of this equipment should be performed by qualied service personnel.
• Before wiring to power supply, turn o electricity at fuse or circuit breaker.
INSTALLER:
See unit label for additional model specications.
WARNING:
• This product contains chemicals known to the State of California to cause cancer, birth defects and/or other reproductive harm. Thoroughly
wash hands after installing, handling, cleaning, or otherwise touching this product.
Installation Guide
Combination Exit / Emergency Light
(LUCE Series)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
When using electrical equipment, basic safety precautions should always be followed including the following.
Save These Instructions
Use only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.
Ceiling Mounting
Connect 20” jumper leads to A.C. input leads in J-box,
fasten J-box bracket to J-box. Use Black wire for 120 volt,
Red wire for 277 volt, White wire is common.
1
Fasten canopy to J-box bracket.
Snap housing to canopy.
Connect and trim input leads to socket leads at upper left
comer of housing wire channel.
Secure face plate to housing. Remove the proper arrow as
required.
2
3
4
5
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 1 of 9
(Rev 05/16/23)
RCMANU5957A LUCE _instsht
Lumination® (LUCE Series) Installation Guide
Back Mounting
Connect 20“ jumper leads to A.C. input leads in J-box,
fasten J-box bracket to J-box. Use Black wire for 120 volt,
Red wire for 277 volt, White wire is common.
1
Remove necessary knockouts and fasten back cover to
J-box.
Snap housing to back cover.
Connect and trim input leads to socket leads at upper left
corner of housing wire channel.
Secure face plate to housing.
2
3
4
5
NOTICE:
MUST WEAR GLOVE FOR ALL INSTALLATION PROCESSES
WARNING: UNUSED WIRES MUST BE CAPPED USING
ENCLOSED WIRE NUTS.
Wiring Diagram
COMBINATION EXIT COMBINATION EXIT WITH REMOTE CAPACITY
RECYCLING INFORMATION
All steel, aluminum, and thermoplastics
parts are recyclable.
All cartons contain recycled materials.
Please recycle responsibly.
Specications subject to change without notice.
  • Page 1 1
  • Page 2 2

Lumination Luce Installation guide

Lumination
Brand
Lumination
Model
Luce
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents